Leonardo Stefanini
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Leonardo Stefanini has a total of 5 co-authors. Here are the top co-authors by number of shared publications:
- Claudio Bianchini
University of Modena and Reggio Emilia,Department of Engineering Enzo Ferrari,Modena,Italy
1 shared publication - Fausto Stella
Politecnico di Torino
1 shared publication - Juan L. Bellido
Department of Electronic Engineering, University of Valencia, 46100 Valencia, Spain
1 shared publication - Mattia Vogni
Department of Engineering “Enzo Ferrari”, University of Modena and Reggio-Emilia, 41125 Modena, Italy
1 shared publication - Vicente Esteve
Department of Electronic Engineering, University of Valencia, 46100 Valencia, Spain
1 shared publication
Latest Publications
- Open Access
- 25 November 2025
- Published by MDPI AG in Electronics
- Vol. 14 (23) , 4625
Application and Development of a Double Asymmetric Voltage Modulation on a Resonant Dual Active Bridge
The growing market penetration of Electric Vehicles (EVs) requires very efficient bidirectional on-board chargers. These converters must allow the power transfer from the grid to the battery of the vehicle and vice versa, since Vehicle to Grid (V2G) applications enable a mitigation of the peak demand and help regulate both the voltage and the frequency of the grid. In this paper, an innovative double asymmetric modulation was studied and applied to a resonant Dual Active Bridge (DAB), CLLC resonant filter configuration. The results of the study showed a significant efficiency boost and an easier controllability of the converter with respect to more traditional modulations or variable frequency techniques, maintaining Zero-Voltage Switching (ZVS) conditions for all the switches in a wide operating range, from 28 to 100% of the maximum power (4–14 kW). A map of optimum points, where converter losses are minimized, is calculated offline through an algorithm in MATLAB R2024a and a proper interpolation between these points allows any output power for each possible voltage level of the battery to be achieved: from 250 V up to 400 V. The modulations are compared and evaluated through simulations carried out in PLECS, both offline and using hardware-in-the-loop (HIL), as well as through experimental tests.
- 25 November 2025
- Published by MDPI AG in Electronics
- Vol. 14 (23) , 4625
Open AccessApplication and Development of a Double Asymmetric Voltage Modulation on a Resonant Dual Active Bridge
The growing market penetration of Electric Vehicles (EVs) requires very efficient bidirectional on-board chargers. These converters must allow the power transfer from the grid to the battery of the vehicle and vice versa, since Vehicle to Grid (V2G) applications enable a mitigation of the peak demand and help regulate both the voltage and the frequency of the grid. In this paper, an innovative double asymmetric modulation was studied and applied to a resonant Dual Active Bridge (DAB), CLLC resonant filter configuration. The results of the study showed a significant efficiency boost and an easier controllability of the converter with respect to more traditional modulations or variable frequency techniques, maintaining Zero-Voltage Switching (ZVS) conditions for all the switches in a wide operating range, from 28 to 100% of the maximum power (4–14 kW). A map of optimum points, where converter losses are minimized, is calculated offline through an algorithm in MATLAB R2024a and a proper interpolation between these points allows any output power for each possible voltage level of the battery to be achieved: from 250 V up to 400 V. The modulations are compared and evaluated through simulations carried out in PLECS, both offline and using hardware-in-the-loop (HIL), as well as through experimental tests.