SLSongyuan Li

Songyuan Li

*This is an algorithmically generated author record based on publicly available information.

Songyuan Li has a total of 19 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Numerical simulation of deformation of flexible ring on power rolling ring

    by Junye Li, Beiran Zhang, Gaopeng Shuai, Chuanfeng Wang, Chao Han, Guodong Ni, Liang Xu, Haihonsg Wu, Xiaobin He

    In this paper, the influence of the deformation of the flexible ring on the performance of the power rolling ring is studied by the finite element simulation method. The results show that the maximum stress of the flexible ring is concentrated in the contact area with the inner and outer conductive rings, and the maximum bending stress increases significantly from 93.5 MPa to 217 MPa with the increase of deformation from 0.3 mm to 0.7 mm. On the other hand, with the increase of deformation, the oscillation of the velocity curve of the probe point on the flexible ring is weakened and tends to be smooth, indicating that the stability of the motion is gradually improved. The research reveals that increasing the deformation can improve the motion stability and also lead to a significant increase in the contact stress, which provides an important basis for the balance design between structural reliability and motion stability of the power rolling ring.

  • Open Access

    Quality Control Technology for Abrasive Flow Precision Machining of a High-Performance Impeller

    by Junye Li, Songyuan Li, Pingping Wei, Changqing Wang, Yanming Li, Ke Liu, Chunlin Liu, Yu Chen, Guiling Wu, Xiao Li, et al.

    The surface quality of high-performance impellers, which feature complex, free-form surfaces and narrow flow channels, is critically important for their performance and efficiency. However, achieving uniform precision polishing on these intricate geometries remains a significant manufacturing challenge, as traditional methods are often inefficient, inaccessible, or cause surface damage. To address this, this study investigates the application of solid–liquid two-phase abrasive flow machining (AFM) as a high-precision finishing solution. Through numerical simulation, we analyzed the polishing effects under two flow channel structures and various machining parameters. The results demonstrate that a gradual flow channel structure significantly enhances processing uniformity and intensity compared to a direct flow channel. Furthermore, increasing the inlet pressure and abrasive viscosity was found to substantially improve both the strength and uniformity of the machining effect across the impeller surface. Experimental validation via an orthogonal test design confirmed that inlet pressure is the most influential factor on the polishing effect, followed by abrasive grain size and the number of processes. The optimized process parameters (6 MPa inlet pressure, 10 process cycles, and 40 µm abrasive grain size) successfully reduced the average surface roughness (Ra) of the high-performance impeller from 0.766 µm to 0.047 µm, representing an improvement of nearly 94%. This study provides a scientifically grounded set of optimal parameters for achieving uniform, high-quality surface finishing of complex impellers using AFM technology.