Hasan Çimen
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Hasan Çimen has a total of 4 co-authors. Here are the top co-authors by number of shared publications:
- İsMail Yabanova
Department of Electrical Engineering, Manisa Celal Bayar University 3 , Manisa
3 shared publications - Veli Yenil
Pamukkale Universitesi
3 shared publications - Recep Akkan
Kutahya Dumlupinar Universitesi
2 shared publications - Recep Akkan
Department of Electronics and Automation, Kütahya Dumlupınar University 1 , Kütahya
1 shared publication
Latest Publications
- 1 May 2026
- Published by AIP Publishing in Journal of Renewable and Sustainable Energy
- Vol. 18 (3)
Application of characteristic curves appropriate for relay coordination in adaptive protection networks containing distributed generation facilities
The integration of distributed generation (DG) facilities into power grids improves energy supply but introduces significant complexity, particularly with respect to protection coordination. Since power output from most DG facilities depends on variable conditions such as wind speed and solar irradiance, the magnitude of short-circuit currents that arise during faults also varies continuously. This variability causes deterioration of overcurrent relay coordination and selectivity, potentially leading to unnecessary power outages and equipment damage. To address this challenge, this study proposes an adaptive protection algorithm that selects the most appropriate relay time-current characteristic curve based on the real-time connection status of DG facilities to the network. The algorithm distinguishes among eight operating modes defined by the on/off states of three DG units and assigns either the standard inverse or extremely inverse characteristic curve accordingly. The proposed method was implemented and validated in a MATLAB/Simulink environment using a modified IEEE 4-bus test system integrated with three squirrel-cage induction generator-based wind turbines. Performance was evaluated across 24 scenarios comprising 8 operating modes and 3 fault locations. Simulation results demonstrate that the proposed algorithm reduces the tripping time of backup relays in 20 out of 24 cases, with improvements ranging from 29.11% to 90.98% compared to conventional adaptive protection. These findings confirm that the proposed method significantly enhances relay coordination, selectivity, and system protection in DG-integrated networks.
- 1 May 2026
- Published by AIP Publishing in Journal of Renewable and Sustainable Energy
- Vol. 18 (3)
Application of characteristic curves appropriate for relay coordination in adaptive protection networks containing distributed generation facilities
The integration of distributed generation (DG) facilities into power grids improves energy supply but introduces significant complexity, particularly with respect to protection coordination. Since power output from most DG facilities depends on variable conditions such as wind speed and solar irradiance, the magnitude of short-circuit currents that arise during faults also varies continuously. This variability causes deterioration of overcurrent relay coordination and selectivity, potentially leading to unnecessary power outages and equipment damage. To address this challenge, this study proposes an adaptive protection algorithm that selects the most appropriate relay time-current characteristic curve based on the real-time connection status of DG facilities to the network. The algorithm distinguishes among eight operating modes defined by the on/off states of three DG units and assigns either the standard inverse or extremely inverse characteristic curve accordingly. The proposed method was implemented and validated in a MATLAB/Simulink environment using a modified IEEE 4-bus test system integrated with three squirrel-cage induction generator-based wind turbines. Performance was evaluated across 24 scenarios comprising 8 operating modes and 3 fault locations. Simulation results demonstrate that the proposed algorithm reduces the tripping time of backup relays in 20 out of 24 cases, with improvements ranging from 29.11% to 90.98% compared to conventional adaptive protection. These findings confirm that the proposed method significantly enhances relay coordination, selectivity, and system protection in DG-integrated networks.
- 31 March 2026
- Published by Journal of the Faculty of Engineering and Architecture of Gazi University in Gazi Üniversitesi Mühendislik-Mimarlık Fakültesi Dergisi
- Vol. 41 (1) , 719-730
Dağıtık üretim tesisleri içeren adaptif korumadaki şebekelerde yeni bir röle koordinasyonu uygulaması
Elektrik dağıtım hatlarının korunması konusu günümüzde popüler olan akıllı şebekelerde olmazsa olmaz bir durumdur. Elektrik dağıtım hatlarının ise gelecekte yetersiz kalacak olması dağıtım hatlarına Dağıtık Üretimlerin (DÜ) bağlanmasını kaçınılmaz kılmaktadır. Elektrik dağıtım hatlarına gün geçtikçe artan bir şekilde DÜ ünitelerinin bağlanması birçok fayda sağlarken bir o kadar da dağıtım hattını karmaşık bir yapıya büründürmektedir. Bu durum elektrik dağıtım hatlarının korunmasını bir derece daha zorlaştırmaktadır. Rüzgâr enerjisi vb. DÜ tesislerinde enerjinin üretimi atmosfer şartlarına bağımlı olduğundan bu durum şebekede oluşabilecek kısa devre akımlarını doğrudan etkilemektedir. Bu sorunlar belirli bir koordinasyonda çalışan rölelerin yanlış çalışmasına, iki rölenin aynı anda çalışmasına (selektivite sağlanamadığından), gereksiz enerji kesintisi gibi durumlara yol açabilmektedir. Bu sorunların önüne geçmek için ise akıllı şebekelerde çift yönlü adaptif korumaya ve buna uygun şekilde çalışacak algoritmalara ihtiyaç duyulmaktadır. Bu çalışmada bahsedilen korumaya uygun bir algoritma önerilmiştir. Günümüz koşullarına ve orijinaline uygun bir şekilde değiştirilen IEEE 4-baralı test sistemi üzerinde yapılan simülasyon çalışmaları önerilen algoritma ile rölelerin daha doğru bir şekilde çalışmasına olanak sağlamıştır. Böylece önerilen algoritma ile çalışan adaptif korumadaki yedek rölelerin çalışması ile normal adaptif korumadaki yedek rölelerin çalışması karşılaştırılmış ve sonuçlar sunulmuştur.
- 31 March 2026
- Published by Journal of the Faculty of Engineering and Architecture of Gazi University in Gazi Üniversitesi Mühendislik-Mimarlık Fakültesi Dergisi
- Vol. 41 (1) , 719-730
Dağıtık üretim tesisleri içeren adaptif korumadaki şebekelerde yeni bir röle koordinasyonu uygulaması
Elektrik dağıtım hatlarının korunması konusu günümüzde popüler olan akıllı şebekelerde olmazsa olmaz bir durumdur. Elektrik dağıtım hatlarının ise gelecekte yetersiz kalacak olması dağıtım hatlarına Dağıtık Üretimlerin (DÜ) bağlanmasını kaçınılmaz kılmaktadır. Elektrik dağıtım hatlarına gün geçtikçe artan bir şekilde DÜ ünitelerinin bağlanması birçok fayda sağlarken bir o kadar da dağıtım hattını karmaşık bir yapıya büründürmektedir. Bu durum elektrik dağıtım hatlarının korunmasını bir derece daha zorlaştırmaktadır. Rüzgâr enerjisi vb. DÜ tesislerinde enerjinin üretimi atmosfer şartlarına bağımlı olduğundan bu durum şebekede oluşabilecek kısa devre akımlarını doğrudan etkilemektedir. Bu sorunlar belirli bir koordinasyonda çalışan rölelerin yanlış çalışmasına, iki rölenin aynı anda çalışmasına (selektivite sağlanamadığından), gereksiz enerji kesintisi gibi durumlara yol açabilmektedir. Bu sorunların önüne geçmek için ise akıllı şebekelerde çift yönlü adaptif korumaya ve buna uygun şekilde çalışacak algoritmalara ihtiyaç duyulmaktadır. Bu çalışmada bahsedilen korumaya uygun bir algoritma önerilmiştir. Günümüz koşullarına ve orijinaline uygun bir şekilde değiştirilen IEEE 4-baralı test sistemi üzerinde yapılan simülasyon çalışmaları önerilen algoritma ile rölelerin daha doğru bir şekilde çalışmasına olanak sağlamıştır. Böylece önerilen algoritma ile çalışan adaptif korumadaki yedek rölelerin çalışması ile normal adaptif korumadaki yedek rölelerin çalışması karşılaştırılmış ve sonuçlar sunulmuştur.
- 26 December 2025
- Published by Journal of Materials and Mechatronics: A in Journal of Materials and Mechatronics: A
- Vol. 6 (2) , 366-380
Overcurrent Relay Coordination in Adaptive Protected Networks with Integrated Wind Energy
The fact that the capacity of electricity distribution networks will be insufficient in the future has forced people to integrate DG (Distributed Generation) facilities into their distribution networks. Although DG facilities provide many benefits to the grid, they also lead to complexity in the distribution network. This situation not only makes it difficult to protect the distribution network but also causes short circuit currents to have a variable structure. Variable short circuit currents cause the relays to activate at the wrong time, causing OCR (Overcurrent Relay) coordination to be disrupted. For this reason, bidirectional relays and adaptive protection are needed in the networks. In this study, the IEEE 4-bus test system, which includes DG facilities and was created in accordance with its original form, was used for simulation studies. In this way, the effect of short circuit current variability is minimized and optimum protection is achieved by quickly adapting to variable network conditions.
- 26 December 2025
- Published by Journal of Materials and Mechatronics: A in Journal of Materials and Mechatronics: A
- Vol. 6 (2) , 366-380
Overcurrent Relay Coordination in Adaptive Protected Networks with Integrated Wind Energy
The fact that the capacity of electricity distribution networks will be insufficient in the future has forced people to integrate DG (Distributed Generation) facilities into their distribution networks. Although DG facilities provide many benefits to the grid, they also lead to complexity in the distribution network. This situation not only makes it difficult to protect the distribution network but also causes short circuit currents to have a variable structure. Variable short circuit currents cause the relays to activate at the wrong time, causing OCR (Overcurrent Relay) coordination to be disrupted. For this reason, bidirectional relays and adaptive protection are needed in the networks. In this study, the IEEE 4-bus test system, which includes DG facilities and was created in accordance with its original form, was used for simulation studies. In this way, the effect of short circuit current variability is minimized and optimum protection is achieved by quickly adapting to variable network conditions.