Ziqi Chen
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Research Interests
Ziqi Chen has a total of 11 co-authors. Here are the top co-authors by number of shared publications:
- Xueren Li
School of Safety Engineering, China University of Mining and Technology 1 , Xuzhou 221116
2 shared publications - Jiaqi Fan
School of Safety Engineering, China University of Mining and Technology 1 , Xuzhou 221116
1 shared publication Jie Li
School of Safety Engineering, China University of Mining and Technology 1 , Xuzhou 221116
1 shared publicationJiyuan Tu
School of Engineering, RMIT University 2 , P. O. Box 71, Bundoora, VIC 3083
1 shared publication- Ruipeng Xu
Department of Chemical Engineering, Faculty of Applied Sciences, Delft University of Technology and J.M. Burgerscentrum Research School for Fluid Mechanics 4 , Van der Maasweg 9, 2629 HZ Delft
1 shared publication - Weihua Yang
The Oak Ridge Institute for Science and Education (ORISE)
1 shared publication
Latest Publications
- 1 June 2026
- Published by AIP Publishing in Physics of Fluids
- Vol. 38 (6)
Effects of mask leakage characteristics on aerosol inhalability and deposition in the human nasal cavity
Frequent emergence of infectious respiratory diseases has highlighted the importance of effective respiratory protection against airborne particle exposure. However, imperfect mask fitting often leads to leakage at the mask–face interface, which significantly influence aerosol inhalability and deposition in the human airway. In this study, a coupled numerical model including the breathing zone, face mask, facial interface, and nasal cavity was developed. The model was used to investigate airflow leakage and the subsequent transport and deposition behavior of inhalable aerosols. Representative leakage scenarios were simulated to evaluate effects of leakage location, breathing intensity, and leakage area on particle transport behavior. Results show that leakage location strongly affects airflow organization and particle transport. Midline leakage produced symmetric flow and deposition in the nasal cavities, while cheek leakage induced pronounced asymmetric deposition. Even with leakage, mask wearing still reduces particle penetration into the deeper respiratory tract. Compared with the no-mask condition, particle penetration decreases by an average of 7.36%, with the largest reduction (13.8%) observed under chin leakage. Increasing breathing intensity enhanced particle inertia and promoted inertial impaction in the upstream nasal regions. As the inhalation rate increased to 60 l/min, the overall nasal deposition efficiency reached 90.6%. In contrast, leakage area mainly redistributed particle deposition locations within the nasal cavity while exerting a limited influence on overall deposition–penetration balance. The findings provided insights into aerosol inhalation exposure under mask leakage conditions. It aimed to improving respirator design and respiratory protection strategies.
- 1 June 2026
- Published by AIP Publishing in Physics of Fluids
- Vol. 38 (6)
Effects of mask leakage characteristics on aerosol inhalability and deposition in the human nasal cavity
Frequent emergence of infectious respiratory diseases has highlighted the importance of effective respiratory protection against airborne particle exposure. However, imperfect mask fitting often leads to leakage at the mask–face interface, which significantly influence aerosol inhalability and deposition in the human airway. In this study, a coupled numerical model including the breathing zone, face mask, facial interface, and nasal cavity was developed. The model was used to investigate airflow leakage and the subsequent transport and deposition behavior of inhalable aerosols. Representative leakage scenarios were simulated to evaluate effects of leakage location, breathing intensity, and leakage area on particle transport behavior. Results show that leakage location strongly affects airflow organization and particle transport. Midline leakage produced symmetric flow and deposition in the nasal cavities, while cheek leakage induced pronounced asymmetric deposition. Even with leakage, mask wearing still reduces particle penetration into the deeper respiratory tract. Compared with the no-mask condition, particle penetration decreases by an average of 7.36%, with the largest reduction (13.8%) observed under chin leakage. Increasing breathing intensity enhanced particle inertia and promoted inertial impaction in the upstream nasal regions. As the inhalation rate increased to 60 l/min, the overall nasal deposition efficiency reached 90.6%. In contrast, leakage area mainly redistributed particle deposition locations within the nasal cavity while exerting a limited influence on overall deposition–penetration balance. The findings provided insights into aerosol inhalation exposure under mask leakage conditions. It aimed to improving respirator design and respiratory protection strategies.
- Open Access
- 18 August 2022
- Published by Springer Nature in Experimental and Computational Multiphase Flow
- Vol. 4 (4) , 389-398
Analysis of occupants’ exposure risk of cough-expelled droplets in the workspace with various mixing ventilation layouts
This study numerically investigated the transport characteristics of the cough-expelled droplets and their corresponding exposure risk of each occupant under various mixing ventilation layouts. Transient simulations were conducted in a conference room, while pathogen-bearing droplets were released by a standing speaker. The results showed that droplet residues (< 40 µm) had a high potential to reach occupant’s breathing zone, among which the number fraction of aerosol residues (< 10 µm) could be nearly doubled compared with that of the rest droplet residues in the breathing zone. Occupants’ exposure risks were found very sensitive to the ventilation layouts. The strong ventilated flow could significantly promote droplet dispersions when those inlets were closely located to the infectious speaker, resulting in all occupants exposed to a considerable fraction of aerosols and droplets within a given exposure time of 300 s. The mixing ventilation layout did not have a consistent performance on restricting the pathogen spread and controlling the occupant’s exposure risk in an enclosed workspace. Its performance could be highly sensitive to the location of the infectious agent. Centralized vent layouts could provide relatively more consistent performance on removing droplets, whilst some local airflow recirculation with locked droplets were noticed.
- 18 August 2022
- Published by Springer Nature in Experimental and Computational Multiphase Flow
- Vol. 4 (4) , 389-398
Open AccessAnalysis of occupants’ exposure risk of cough-expelled droplets in the workspace with various mixing ventilation layouts
This study numerically investigated the transport characteristics of the cough-expelled droplets and their corresponding exposure risk of each occupant under various mixing ventilation layouts. Transient simulations were conducted in a conference room, while pathogen-bearing droplets were released by a standing speaker. The results showed that droplet residues (< 40 µm) had a high potential to reach occupant’s breathing zone, among which the number fraction of aerosol residues (< 10 µm) could be nearly doubled compared with that of the rest droplet residues in the breathing zone. Occupants’ exposure risks were found very sensitive to the ventilation layouts. The strong ventilated flow could significantly promote droplet dispersions when those inlets were closely located to the infectious speaker, resulting in all occupants exposed to a considerable fraction of aerosols and droplets within a given exposure time of 300 s. The mixing ventilation layout did not have a consistent performance on restricting the pathogen spread and controlling the occupant’s exposure risk in an enclosed workspace. Its performance could be highly sensitive to the location of the infectious agent. Centralized vent layouts could provide relatively more consistent performance on removing droplets, whilst some local airflow recirculation with locked droplets were noticed.