Dimitri Z. C. Silva
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Dimitri Z. C. Silva has a total of 4 co-authors. Here are the top co-authors by number of shared publications:
- Alexsandro dos Santos Silveira
POLO Laboratories—Cooling Systems Division, Department of Mechanical Engineering, Federal University of Santa Catarina, Florianópolis 88040-535, SC, Brazil
1 shared publication - Carlos A. R. Nascimento
LATAM System Engineering—Food Preservation, Electrolux do Brasil S.A., Curitiba 81520-620, PR, Brazil
1 shared publication - Christian J. L. Hermes
POLO Laboratories—Cooling Systems Division, Department of Mechanical Engineering, Federal University of Santa Catarina, Florianópolis 88040-535, SC, Brazil
1 shared publication - Diogo Lôndero da Silva
Laboratory of Vehicular Refrigeration—ReVe, Department of Mobility Engineering, Federal University of Santa Catarina, Joinville 89219-600, SC, Brazil
1 shared publication
Latest Publications
- Open Access
Modeling of Non-Uniform Frost Accretion on ‘No-Frost’ Tube-Fin Evaporators
This study presents a transient two-dimensional model devised to predict frost build-up, pressure drop, and sensible and latent heat transfer rates in tube-fin evaporators, commonly used in ‘frost-free’ refrigerators. Based on the first principles of mass, momentum, and energy conservation for the airflow and the frost layer, the model accurately simulates evaporator blockage over time. Furthermore, it incorporates the interaction between the heat exchanger air-side impedance and the fan performance characteristic curve, using an iterative fluid-dynamic sub-model that predicts airflow reduction and redistribution in an evaporator with three fin densities. Frost accretion experiments were conducted using a purpose-built test setup consisting of a bottom-mount refrigerator cabinet maintained at controlled temperature and humidity in both the fresh and frozen-food compartments. Model validation demonstrated that the predicted results closely matched experimental observations. The results show that localized frost accumulation at fin density transitions causes severe airflow blockage, resulting in a 75% reduction in effective heat transfer area due to uneven air distribution. Finally, an analysis of two dimensionless competing indices demonstrates that fin density selection involves a critical trade-off between the initial cooling capacity and long-term frost resilience.
Open AccessModeling of Non-Uniform Frost Accretion on ‘No-Frost’ Tube-Fin Evaporators
This study presents a transient two-dimensional model devised to predict frost build-up, pressure drop, and sensible and latent heat transfer rates in tube-fin evaporators, commonly used in ‘frost-free’ refrigerators. Based on the first principles of mass, momentum, and energy conservation for the airflow and the frost layer, the model accurately simulates evaporator blockage over time. Furthermore, it incorporates the interaction between the heat exchanger air-side impedance and the fan performance characteristic curve, using an iterative fluid-dynamic sub-model that predicts airflow reduction and redistribution in an evaporator with three fin densities. Frost accretion experiments were conducted using a purpose-built test setup consisting of a bottom-mount refrigerator cabinet maintained at controlled temperature and humidity in both the fresh and frozen-food compartments. Model validation demonstrated that the predicted results closely matched experimental observations. The results show that localized frost accumulation at fin density transitions causes severe airflow blockage, resulting in a 75% reduction in effective heat transfer area due to uneven air distribution. Finally, an analysis of two dimensionless competing indices demonstrates that fin density selection involves a critical trade-off between the initial cooling capacity and long-term frost resilience.