Wen-Feng Gu
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Wen-Feng Gu has a total of 11 co-authors. Here are the top co-authors by number of shared publications:
- Takayuki Iwama
Institute of Multidisciplinary Research for Advanced Materials, Tohoku University
3 shared publications - Elizaveta Cheremisina
Institute of Multidisciplinary Research for Advanced Materials, Tohoku University
2 shared publications - Ryo Inoue
Institute of Multidisciplinary Research for Advanced Materials, Tohoku University
2 shared publications - Shigeru Ueda
Institute of Multidisciplinary Research for Advanced Materials, Tohoku University
2 shared publications Bing Xie
1 shared publicationFuga Sato
Graduate School of Engineering, Tohoku University
1 shared publication
Latest Publications
- Open Access
- 15 November 2026
- Published by Iron and Steel Institute of Japan in ISIJ International
- Vol. 66 (12) , 1675-1682
Foaming Behavior of FeO-Containing Slag during Pulverized Coal Injection under Continuous Ar Blowing
To clarify the foaming behavior of FeO-containing slags during pulverized coal injection, calcined anthracite powder was introduced under continuous Ar gas blowing, and the temporal change in foam height was measured. CaO–SiO2–FeO–Al2O3 and CaO–SiO2–FeO–MgO slags were used. Relatively large bubbles were formed when only Ar gas was blown, whereas after pulverized coal injection, a film-like structure formed on the slag surface and the foam height increased markedly. For the Al2O3-containing slag, injection of 0.1 g of pulverized coal resulted in maximum foam heights of approximately 30 mm in the first injection and 65 mm in the second injection. SEM observation and EDS analysis revealed phases corresponding to wüstite, gehlenite, and fine metallic Fe in the upper region of the Al2O3-containing slag, and phases corresponding to wüstite and metallic Fe in the film-like sample from the MgO-containing slag. In foaming caused only by Ar gas blowing, the foam height increased on the higher-viscosity side, whereas during pulverized coal injection, the maximum foam height increased with increasing temperature. The MgO-containing slag showed a lower foam height than the Al2O3-containing slag under Ar gas blowing alone, but exhibited rapid and pronounced foaming during pulverized coal injection. These results suggest that foaming during pulverized coal injection is likely a multiphase reaction phenomenon governed by the combined effects of liquid-phase viscosity, gas generation through the carbonaceous material–FeO reaction, dispersion of solid phases or metallic Fe particles, and gas retention within the foam films.
- 15 November 2026
- Published by Iron and Steel Institute of Japan in ISIJ International
- Vol. 66 (12) , 1675-1682
Open AccessFoaming Behavior of FeO-Containing Slag during Pulverized Coal Injection under Continuous Ar Blowing
To clarify the foaming behavior of FeO-containing slags during pulverized coal injection, calcined anthracite powder was introduced under continuous Ar gas blowing, and the temporal change in foam height was measured. CaO–SiO2–FeO–Al2O3 and CaO–SiO2–FeO–MgO slags were used. Relatively large bubbles were formed when only Ar gas was blown, whereas after pulverized coal injection, a film-like structure formed on the slag surface and the foam height increased markedly. For the Al2O3-containing slag, injection of 0.1 g of pulverized coal resulted in maximum foam heights of approximately 30 mm in the first injection and 65 mm in the second injection. SEM observation and EDS analysis revealed phases corresponding to wüstite, gehlenite, and fine metallic Fe in the upper region of the Al2O3-containing slag, and phases corresponding to wüstite and metallic Fe in the film-like sample from the MgO-containing slag. In foaming caused only by Ar gas blowing, the foam height increased on the higher-viscosity side, whereas during pulverized coal injection, the maximum foam height increased with increasing temperature. The MgO-containing slag showed a lower foam height than the Al2O3-containing slag under Ar gas blowing alone, but exhibited rapid and pronounced foaming during pulverized coal injection. These results suggest that foaming during pulverized coal injection is likely a multiphase reaction phenomenon governed by the combined effects of liquid-phase viscosity, gas generation through the carbonaceous material–FeO reaction, dispersion of solid phases or metallic Fe particles, and gas retention within the foam films.
- Open Access
- 21 October 2026
- Published by Elsevier in Results in Engineering
- Vol. 32
Mineral phase evolution of steelmaking slag under industrial treatment processes and its implications for potential volume stability
- 21 October 2026
- Published by Elsevier in Results in Engineering
- Vol. 32
Open AccessMineral phase evolution of steelmaking slag under industrial treatment processes and its implications for potential volume stability
- 1 January 2026
- Published by Iron and Steel Institute of Japan in ISIJ International
- Vol. 66 (9) , 971-981
Distribution and Enrichment Behavior of Samarium in CaO–SiO2–FeO–P2O5–MgO Slag for Permanent Magnet Recycle
- 1 January 2026
- Published by Iron and Steel Institute of Japan in ISIJ International
- Vol. 66 (9) , 971-981
Distribution and Enrichment Behavior of Samarium in CaO–SiO2–FeO–P2O5–MgO Slag for Permanent Magnet Recycle