Abstract
This paper proposes a single-input single-output (SISO) digital predistortion (DPD) model for linearizing millimeter-wave (mm-wave) RF beamforming arrays. It starts with a dual-input power amplifier (PA) model that accounts for steering angle-dependent load modulation effects. This dual-input model is then transformed into a SISO model under the assumption of weak PA nonlinearity and RF beamforming architecture. The underlying coefficients of the SISO array model incorporate the beamforming weights, antenna cross-coupling, channel coefficients, and any possible phase-shifter gain variation with phase shift setting. An over-the-air (OTA) measurement setup is finally developed to validate the capacity of a SISO DPD model to linearize two different arrays-under-test with 4 and 64 elements and radiating mm-wave modulated signals with 320- and 800-MHz bandwidth. Although, in principle, the DPD coefficients should be retrained for each steering angle, experimental results have shown that the same set of coefficients can be used over a wide range of steering angles, and only a few sets of trained DPD coefficients are sufficient to minimize the distortion in a mm-wave RF beamforming array across a 120° steering range.
Funding Information
  • Natural Sciences and Engineering Research Council of Canada

This publication has 17 references indexed in Scilit: