Yehia Beltagy
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Yehia Beltagy has a total of 5 co-authors. Here are the top co-authors by number of shared publications:
- Patrick Mitran
Department of Electrical and Computer Engineering, University of Waterloo, Waterloo, Canada
2 shared publications - Slim Boumaiza
University of Waterloo
2 shared publications - Ahmed Ben Ayed
Department of Electrical and Computer Engineering, University of Waterloo, Waterloo, ON, Canada
1 shared publication - Eric Ng
Anokiwave Inc., Billerica, MA, USA
1 shared publication - Giovanni Scarlato
RF/MMIC Group, Department of Electrical and Computer Engineering, University of Waterloo, Waterloo, ON, Canada
1 shared publication
Latest Publications
- 16 July 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Microwave Theory and Techniques
- Vol. 67 (11) , 4479-4492
Digital Predistortion of Millimeter-Wave RF Beamforming Arrays Using Low Number of Steering Angle-Dependent Coefficient Sets
This paper proposes a single-input single-output (SISO) digital predistortion (DPD) model for linearizing millimeter-wave (mm-wave) RF beamforming arrays. It starts with a dual-input power amplifier (PA) model that accounts for steering angle-dependent load modulation effects. This dual-input model is then transformed into a SISO model under the assumption of weak PA nonlinearity and RF beamforming architecture. The underlying coefficients of the SISO array model incorporate the beamforming weights, antenna cross-coupling, channel coefficients, and any possible phase-shifter gain variation with phase shift setting. An over-the-air (OTA) measurement setup is finally developed to validate the capacity of a SISO DPD model to linearize two different arrays-under-test with 4 and 64 elements and radiating mm-wave modulated signals with 320- and 800-MHz bandwidth. Although, in principle, the DPD coefficients should be retrained for each steering angle, experimental results have shown that the same set of coefficients can be used over a wide range of steering angles, and only a few sets of trained DPD coefficients are sufficient to minimize the distortion in a mm-wave RF beamforming array across a 120° steering range.
- 16 July 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Microwave Theory and Techniques
- Vol. 67 (11) , 4479-4492
Digital Predistortion of Millimeter-Wave RF Beamforming Arrays Using Low Number of Steering Angle-Dependent Coefficient Sets
This paper proposes a single-input single-output (SISO) digital predistortion (DPD) model for linearizing millimeter-wave (mm-wave) RF beamforming arrays. It starts with a dual-input power amplifier (PA) model that accounts for steering angle-dependent load modulation effects. This dual-input model is then transformed into a SISO model under the assumption of weak PA nonlinearity and RF beamforming architecture. The underlying coefficients of the SISO array model incorporate the beamforming weights, antenna cross-coupling, channel coefficients, and any possible phase-shifter gain variation with phase shift setting. An over-the-air (OTA) measurement setup is finally developed to validate the capacity of a SISO DPD model to linearize two different arrays-under-test with 4 and 64 elements and radiating mm-wave modulated signals with 320- and 800-MHz bandwidth. Although, in principle, the DPD coefficients should be retrained for each steering angle, experimental results have shown that the same set of coefficients can be used over a wide range of steering angles, and only a few sets of trained DPD coefficients are sufficient to minimize the distortion in a mm-wave RF beamforming array across a 120° steering range.
- 2 November 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Microwave Theory and Techniques
- Vol. 67 (1) , 267-277
Direct Learning Algorithm for Digital Predistortion Training Using Sub-Nyquist Intermediate Frequency Feedback Signal
In this paper, a novel direct learning algorithm is proposed to identify the digital predistortion (DPD) coefficients that linearize a power amplifier (PA) using sub-Nyquist sampled intermediate frequency (IF) output of a heterodyne transmitter observation receiver (TOR). The learning algorithm is complemented with a joint time and phase alignment procedure to compensate for the unknown phase of the IF carrier as well as the delay between the PA input and output signals. By sub-Nyquist sampling at IF, the proposed method avoids the need for challenging receiver calibration that compensates for significant IQ imbalance exhibited by direct conversion receivers. Furthermore, it provides a very attractive flexibility in choosing the IF and consequently allows for a high subsampling factor. It is also extended to account for the nonflat frequency response of the TOR, thus avoiding the need for an explicit calibration step. Finally, measurement results were performed to linearize a PA demonstrator driven by a 320-MHz wide carrier aggregated LTE signal centered at 31 GHz using a complexity reduced Volterra-based DPD. Excellent linearization capacity (ACPR of 50 dBc and normalized mean square error of 2%) using significantly low sampling rates (as low as 40 Msps) is reported.
- 2 November 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Microwave Theory and Techniques
- Vol. 67 (1) , 267-277
Direct Learning Algorithm for Digital Predistortion Training Using Sub-Nyquist Intermediate Frequency Feedback Signal
In this paper, a novel direct learning algorithm is proposed to identify the digital predistortion (DPD) coefficients that linearize a power amplifier (PA) using sub-Nyquist sampled intermediate frequency (IF) output of a heterodyne transmitter observation receiver (TOR). The learning algorithm is complemented with a joint time and phase alignment procedure to compensate for the unknown phase of the IF carrier as well as the delay between the PA input and output signals. By sub-Nyquist sampling at IF, the proposed method avoids the need for challenging receiver calibration that compensates for significant IQ imbalance exhibited by direct conversion receivers. Furthermore, it provides a very attractive flexibility in choosing the IF and consequently allows for a high subsampling factor. It is also extended to account for the nonflat frequency response of the TOR, thus avoiding the need for an explicit calibration step. Finally, measurement results were performed to linearize a PA demonstrator driven by a 320-MHz wide carrier aggregated LTE signal centered at 31 GHz using a complexity reduced Volterra-based DPD. Excellent linearization capacity (ACPR of 50 dBc and normalized mean square error of 2%) using significantly low sampling rates (as low as 40 Msps) is reported.