Airborne-Particle Abrasion vs. Hydrofluoric Acid Etching of Dental Ceramics: Impact on the Tensile Bond Strength
Open Access
- 25 November 2024
- Vol. 17 (23) , 5758
Abstract
This study evaluated whether airborne-particle abrasion could be an alternative to hydrofluoric acid etching as a pretreatment for the adhesive bonding of silicate ceramic restorations. Feldspar (FEL; n = 100), lithium silicate (LiSi; n = 100), and zirconia (ZrO2; (n = 80) substrates were CAD/CAM-fabricated and airborne-particle-abraded with Al2O3 (25 µm or 50 µm of mean particle size) at pressures of 0.05 or 0.1 MPa. The controls included FEL (60 s) and LiSi (20 s) etched with hydrofluoric acid. The surface free energy (SFE) and roughness (Ra) were measured. For the tensile bond strength (TBS), surfaces were conditioned using a primer (Monobond Plus) and luted to a resin composite (Variolink Esthetic). TBS was assessed initially (24 h, 37 °C water storage) and after thermocycling (5/55 °C, 10,000×). Statistical analysis (SPSS, V29) was performed using a one-way ANOVA, post hoc Scheffé, and a two-group t-test (p = 0.05). Abrasion with 50 µm and 0.1 MPa induced the highest Ra values across the materials (62.5 ± 3.88 µm). ZrO2 exhibited a higher TBS (35.4–49.5 MPa) than FEL and LiSi. For aged LiSi, the specimens treated at 0.1 MPa showed a higher TBS (18.7 ± 9.0 MPa) than those treated at 0.05 MPa, regardless of the particle size. The etched and aged FEL showed a higher SFE but a lower TBS compared to abrasion. Al2O3 particle abrasion (25 or 50 µm at 0.1 MPa) may replace etching for silicate-based ceramics, while 50 µm is recommended for ZrO2 at either pressure.Keywords
This publication has 40 references indexed in Scilit:
- Interaction of silane with 10-MDP on affecting surface chemistry and resin bonding of zirconiaDental Materials, 2022
- Effects of air-abrasion pressure on mechanical and bonding properties of translucent zirconiaClinical Oral Investigations, 2020
- Bonding to new CAD/CAM resin composites: influence of air abrasion and conditioning agents as pretreatment strategyClinical Oral Investigations, 2018
- Roughness, surface energy, and superficial damages of CAD/CAM materials after surface treatmentClinical Oral Investigations, 2018
- Mechanical reliability of air-abraded and acid-etched bonded feldspar ceramicDental Materials, 2016
- Impact of air‐abrasion on fracture load and failure type of veneered anterior Y‐TZP crowns before and after chewing simulationJournal of Biomedical Materials Research Part B: Applied Biomaterials, 2012
- Possible hazardous effects of hydrofluoric acid and recommendations for treatment approach: a reviewClinical Oral Investigations, 2011
- Effect of thermocycling on bond strength of luting cements to zirconia ceramicDental Materials, 2006
- Effect of surface treatment on the shear bond strength of three resin cements to a machinable feldspatic ceramicJournal of Biomedical Materials Research Part B: Applied Biomaterials, 2005
- Effect of sandblasting on the long‐term performance of dental ceramicsJournal of Biomedical Materials Research Part B: Applied Biomaterials, 2004