A Rapid Phase-Error Self-Detection and Compensation Architecture for MEMS Gyroscopes
- 1 November 2026
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Sensors Journal
- Vol. 26 (21) , 32209-32218
Abstract
No abstract availableFunding Information
- National Natural Science Foundation of China (U21A6003)
This publication has 29 references indexed in Scilit:
- A temperature self-calibrated MEMS gyroscope with 0.007°/h/K bias drift coefficient using real-time parametric quality factor control and mode matchingMicrosystems & Nanoengineering, 2026
- Phase error analysis for MEMS gyroscopes operational modes based on force-to-rebalance rate measurement modeMicrosystems & Nanoengineering, 2026
- Low-cost MEMS gyroscope performance improvement under unknown disturbances through deep learning-based arraySensors and Actuators A: Physical, 2024
- MEMS and MOEMS Gyroscopes: A ReviewPhotonic Sensors, 2023
- Effects of both the drive- and sense-mode circuit phase delay on MEMS gyroscope performance and real-time suppression of the residual fluctuation phase errorJournal of Micromechanics and Microengineering, 2021
- Effect of circuit phase delay on bias stability of MEMS gyroscope under force rebalance detection and self-compensation methodJournal of Micromechanics and Microengineering, 2019
- Analyzing the Impact of Phase Errors in Quadrature Cancellation Techniques for MEMS Capacitive Gyroscopes2018
- One-time frequency sweep to eliminate IQ coupling in MEMS vibratory gyroscopes2016
- Vacuum sealed and getter activated MEMS Quad Mass Gyroscope demonstrating better than 1.2 million quality factor2016
- Readout and Control Electronics for a Microelectromechanical Gyroscope2006