Effect of co‐agents on adhesion between peroxide cured ethylene–propylene–diene monomer and thermoplastics in two‐component injection molding
- 20 August 2019
- journal article
- research article
- Published by Wiley in Journal of Applied Polymer Science
- Vol. 137 (9)
Abstract
Two‐component (2K) injection‐molded products combining ethylene–propylene–diene monomer (EPDM) with polar or nonpolar thermoplastics require strong interfacial bonding. To optimize the adhesion, co‐agents trimethylolpropane trimethacrylate (TMPT) and triallyl cyanurate (TAC) are compared and concentrations were varied between 0 and 12 parts per hundred rubber (phr). Changes in material compatibility were characterized by contact angle measurements at high temperature, the adhesion was evaluated by tensile testing, and physicomechanical properties of the EPDM bulk were analyzed. Results show that with polypropylene, the adhesion increases to an optimum (3 phr TAC or 6 phr TMPT) independent of the co‐agent type, while for polyethylene only TAC (1.5 phr) effectively boosts adhesion. It is surmised that these optimal concentrations promote crosslinking reactions at the interface. For polycarbonate and acrylonitrile–butadiene–styrene, increasing TAC concentration causes higher adhesion due to improved compatibility. Furthermore, physicomechanical bulk properties change significantly with co‐agent concentrations, making the optimal curing composition application dependent. © 2019 Wiley Periodicals, Inc. J. Appl. Polym. Sci. 2020, 137, 48414.Keywords
Funding Information
- Fonds Wetenschappelijk Onderzoek (1SB0319N)
This publication has 22 references indexed in Scilit:
- Effect of process parameters on the adhesion strength in two‐component injection molding of thermoset rubbers and thermoplasticsJournal of Applied Polymer Science, 2018
- Wetting measurements as a tool to predict the thermoplastic/thermoset rubber compatibility in two‐component injection moldingJournal of Applied Polymer Science, 2017
- Two-component injection moulding of thermoset rubber in combination with thermoplastics by thermally separated mould cavities and rapid heat cyclingThe International Journal of Advanced Manufacturing Technology, 2017
- Sulphur and peroxide vulcanisation of rubber compounds – overviewChemical Papers, 2016
- The Effect of Peroxide Cross-Linking on the Properties of Low-Density PolyethyleneJournal of Macromolecular Science, Part B, 2013
- Thermoplastic elastomers based on high‐density polyethylene, ethylene–propylene–diene terpolymer, and ground tire rubber dynamically vulcanized with dicumyl peroxideJournal of Applied Polymer Science, 2013
- Effect of different types of peroxides on properties of vulcanized EPDM + PP blendsPolymer Composites, 2010
- Studies on the influence of structurally different peroxides in polypropylene/ethylene alpha olefin thermoplastic vulcanizates (TPVs)Express Polymer Letters, 2008
- Influence of Various Peroxides in PP/EPDM Thermoplastic Vulcanizates at Varied Blend RatiosJournal of Elastomers & Plastics, 2006
- Peroxide Vulcanization of ElastomersRubber Chemistry and Technology, 2001