Optimization of FC-CSP and MLCC Soldering Process Using Type 7 Solder Paste
Open Access
- 30 April 2022
- journal article
- research article
- Published by The Korean Welding and Joining Society in Journal of Welding and Joining
- Vol. 40 (2) , 165-174
Abstract
To confirm the possibility of simultaneous bonding between Si chip and multilayer ceramic capacitors (MLCCs), vacuum reflow soldering is performed between a Si chip and each of 2012, 1608, 1005, 0603, and 0402 MLCCs using Type-7 Sn-3.0Ag-0.5Cu (SAC305) and Sn-0.7Cu solder pastes. To enable an unbiased comparison with the vacuum reflow process, the Si chip and MLCCs are bonded via thermo-compression (TC) bonding and hot air reflow soldering, respectively. The maximum void content of Si chip solder joints bonded via vacuum reflow is 8%. At the MLCC solder joints, the void content yielded by vacuum reflow is lower than that yielded by hot air reflow. The bonding strength of the MLCC solder joint afforded by vacuum reflow is higher than that afforded by hot air reflow. Vacuum reflow is superior to hot air reflow in terms of the void content and bonding strength of the MLCC solder joint. After performing a thermal cycle test (TCT), a crack appeared at the Si chip solder joint bonded by TC bonding. The Cu pillar/Sn-2.5Ag bump is susceptible to cracks after the TCT owing to the insufficient bonding layer thickness yielded; however, the SAC305 sample from vacuum reflow is stable. Meanwhile, (Cu,Ni)6Sn5, Ni3P, and Ag3Sn intermetallic compounds are formed at the MLCC solder joints and then further developed after the TCT. The results of this study indicate the possibility of co-bonding Si chip with MLCCs for semiconductor packaging.Keywords
Funding Information
- Ministry of Trade, Industry and Energy (20011427)
This publication has 10 references indexed in Scilit:
- MLCC Solder Joint Property with Vacuum and Hot Air Reflow Soldering ProcessesJournal of Welding and Joining, 2021
- Flip Chip - Chip Scale Package Bonding Technology with Type 7 Solder Paste PrintingJournal of Welding and Joining, 2021
- Growth Behavior of Intermetallic Compounds in Various Solder Joints Induced by ElectromigrationJournal of Welding and Joining, 2021
- Effect of Thin ENEPIG Plating Thickness on Interfacial Reaction and Brittle Fracture Rate of Sn-3.0Ag-0.5Cu Solder JointsJournal of Welding and Joining, 2018
- Interfacial reactions and mechanical strength of Sn-3.0Ag-0.5Cu/0.1㎛-Ni thin ENEPIG solder jointJournal of Welding and Joining, 2017
- Solderability of thin ENEPIG plating Layer for Fine Pitch Package applicationJournal of the Microelectronics and Packaging Society, 2017
- Thermal Compression Bonding of 30um Pitch Cu Pillar Microbump on Organic Substrate with Bare Cu Bondpad2016
- Study on Joint of Micro Solder Bump for Application of Flexible ElectronicsJournal of Welding and Joining, 2013
- Interfacial Properties with Kind of Surface Finish and Sn-Ag Based Lead-free SolderJournal of Welding and Joining, 2009
- Thermal Shock Cycles Optimization of Sn-3.0 Ag-0.5 Cu/OSP SolderJoint with Bonding Strength Variation for Electronic ComponentsKorean Journal of Materials Research, 2007