Investigation of Parameter Sensitivity and the Physical Mechanism for the Formation of a Core-Skin-Core (CSC) Structure in Two-Stage Co-Injection Molding
Open Access
Abstract
One of the main challenges in co-injection molding is how to predict the skin to core morphology accurately and then manage it properly, especially after skin material has been broken through. In this study, the formation of the Core-Skin-Core (CSC) structure and its physical mechanism in a two-stage co-injection molding has been studied based on the ASTM D638 TYPE V system by using both numerical simulation and experimental observation. Results showed that when the skin to core ratio is selected properly (say 30/70), the CSC structure can be observed clearly at central location for 30SFPP/30SFPP system. When the skin to core ratio and operation conditions are fixed, regardless of material arrangement (including 30SFPP/30SFPP; PP/PP; 30SFPP/PP; and PP/30SFPP systems), the morphologies of the CSC structures are very close for all systems. This CSC structure can be further validated by using μ-CT scan and image analysis technologies perfectly. Furthermore, the influences of various operation parameters on the CSC structure variation have been investigated. Results exhibited that the CSC structure does not change significantly irrespective of the flow rate changing, melt temperature varying, or even mold temperature being modified. Moreover, the mechanism to generate the CSC structure can be derived using the melt front movement of the numerical simulation. It is worth noting that after the skin material was broken through, the core material travelled ahead with fountain flow to occupy the flow front. In the same period, the proper amount of skin material with certain inertia of enough kinetic energy will keep going to penetrate the new coming core material to travel until the end of filling. It ends up with this special CSC structure.Keywords
This publication has 26 references indexed in Scilit:
- Numerical simulation of the sequential coinjection molding process based on level set methodPolymer Engineering & Science, 2014
- Birefringence and interface in sequential co‐injection molding of amorphous polymers: Simulation and experimentPolymer Engineering & Science, 2014
- Co‐Injection Molded New Green Composites from Biodegradable Polyesters and Miscanthus FibersMacromolecular Materials and Engineering, 2013
- Automated segmentation of electron tomograms for a quantitative description of actin filament networksJournal of Structural Biology, 2012
- Co‐injection molding of immiscible polymers: Skin‐core structure and adhesion studiesPolymer Engineering & Science, 2011
- Study on mechanical properties and material distribution of sandwich plaques molded by co‐injectionPolymer Composites, 2005
- The Flow Behavior of Core Material and Breakthrough Phenomenon in Sandwich Injection MoldingInternational Polymer Processing, 2003
- Three‐dimensional simulation of multi‐material injection molding: Application to gas‐assisted and co‐injection moldingPolymer Engineering & Science, 2003
- Visual analysis of the flow behavior of core material in a fork portion of plastic sandwich injection moldingPolymer Testing, 2003
- Co‐injection molding: Effect of processing on material distribution and mechanical properties of a sandwich molded platePolymer Engineering & Science, 2000