Tuning Modal Behavior of Additively Manufactured Lattice Structures
- 8 February 2024
- journal article
- research article
- Published by ASME International in Journal of Engineering for Gas Turbines and Power
- Vol. 146 (7) , 1-11
Abstract
Thanks to the increasingly widespread additive manufacturing technology and promising properties, the use of lattice structures (LS) is becoming increasingly frequent. LS allows the components to be designed with tunable stiffness, which can unlock the control of natural frequencies. However, crucial challenges must be faced to integrate LS into the typical design process. In this work, an experimental and numerical study of LS-enabled tuning of natural frequencies in mechanical components are proposed. In a first step, the difficulties arising with the large amount of finite element method (FEM) nodes, that are required to predict LS complex shapes in detail, are overcome by modeling LS with an elastic metamaterial whose stiffness properties are determined through ad hoc finite element analyses. After that, a simplified investigation can be conducted on the modal properties of components with fixed external shape and variable internal LS filling, based on triply periodic minimal surfaces (TPMS) lattices. In those conditions, the parameters of the LS core can be tuned to control and optimize the global modal frequencies of the entire geometry. In addition, the admissible range of frequencies can be estimated. Optimized plates results are validated through an experimental test campaign on additively manufactured specimens made with laser powder bed fusion technology. The samples are hammer-tested with various boundary conditions while laser sensors measure the oscillation data of selected points. Finally, estimated and identified natural frequencies were compared. The described model is suitable to be implemented in an automated tool for designers.Keywords
This publication has 19 references indexed in Scilit:
- Experimental and Numerical Modal Characterization for Additively Manufactured Triply Periodic Minimal Surface Lattice Structures: Comparison between Free‐Size and Homogenization‐Based Optimization MethodsAdvanced Engineering Materials, 2023
- A comparative investigation on the mechanical properties and cytotoxicity of Cubic, Octet, and TPMS gyroid structures fabricated by selective laser melting of stainless steel 316LJournal of the Mechanical Behavior of Biomedical Materials, 2022
- Numerical investigation of the effective mechanical properties and local stress distributions of TPMS-based and strut-based lattices for biomedical applicationsJournal of the Mechanical Behavior of Biomedical Materials, 2022
- Isotropic design and mechanical characterization of TPMS-based hollow cellular structuresComposite Structures, 2022
- Modal characterization of additively manufactured TPMS structures: comparison between different modeling methodsThe International Journal of Advanced Manufacturing Technology, 2020
- Heat transfer enhancement of wedge-shaped channels by replacing pin fins with Kagome lattice structuresInternational Journal of Heat and Mass Transfer, 2019
- Smooth-shell metamaterials of cubic symmetry: Anisotropic elasticity, yield strength and specific energy absorptionActa Materialia, 2019
- Advanced lightweight 316L stainless steel cellular lattice structures fabricated via selective laser meltingMaterials & Design (1980-2015), 2014
- Topology optimization approachesStructural and Multidisciplinary Optimization, 2013
- Evaluations of cellular lattice structures manufactured using selective laser meltingInternational Journal of Machine Tools and Manufacture, 2012