Induced Currents and AC Losses Models for a Butt-Joint With Rutherfords Shunts
- 28 February 2020
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Applied Superconductivity
- Vol. 30 (4) , 1-5
Abstract
The ITER Central Solenoid (CS) has terminal butt-type joints called Coaxial joints. It was decided to study a design of this joint with rutherford shunts, and to build models for its resistive and inductive behaviors. In particular, the behavior of the joint under magnetic field transients is investigated with various ana-lytical models that are compared with a FEM model. The key point of the study was to verify that the induced currents were reasonable and would not induce flux jumps in the rutherfords. A prototype with simplified geometry was tested in the CEA Josefa facility under various field ramps. The results are pre-sented and discussed.Keywords
Funding Information
- ITER (IO/SCT/17/4300001621)
This publication has 10 references indexed in Scilit:
- Preparation of the ITER Central Solenoid AssemblyIEEE Transactions on Applied Superconductivity, 2020
- Examination of ITER Central Solenoid prototype jointsFusion Engineering and Design, 2019
- R&D effort for ITER Central Solenoid2015
- ITER Central Solenoid design2013
- Modeling of the electro-mechanical behavior of ITER Nb3Sn cable in conduit conductorsSuperconductor Science and Technology, 2012
- JackPot: A novel model to study the influence of current non-uniformity and cabling patterns in cable-in-conduit conductorsCryogenics, 2010
- Detailed design of the ITER central solenoidFusion Engineering and Design, 2009
- The CEA JOSEFA Test Facility for Subsize Conductors and JointsIEEE Transactions on Applied Superconductivity, 2004
- Electrical and thermal designs and analyses of joints for the ITER PF coilsIEEE Transactions on Applied Superconductivity, 2002
- Losses in superconducting composites under high rate pulsed transverse fieldIEEE Transactions on Magnetics, 1979