Construction of a kinetic equation of carbon removal for controlling steel melting in the metallurgical system “cupola furnace – small converter”
Open Access
- 4 April 2025
- journal article
- Published by Private Company Technology Center in Technology audit and production reserves
- Vol. 2 (1(82)) , 19-23
Abstract
The object of research in the paper is the process of steelmaking in a small converter, which works in tandem with a cupola furnace. The existing problem is that the control of the process of obtaining steel in an oxygen converter is complicated by the need to determine in real time the current chemical composition of the melt, in particular carbon. This is due to the fact that the rate of carbon removal is too high, as a result of which the process of carbon removal is transient. Therefore, it is too difficult to implement regulation based on feedback on continuous measurement. The presence of the specified problem requires solutions related to the possibilities of developing or improving software control of the process. It is shown that in certain sections of the process within each time section of oxygen purging of the melt in the converter, the kinetic curve has a linear form with a constant coefficient value in front of the inlet mine. But the value of the initial coefficient for each equation that describes the process within its limits changes. This allows to state that in case of a change in the initial condition, the kinetic curves shift relative to each other in parallel. On this basis, a system of equations has been constructed that describes the process of carbon removal in a small oxygen converter that receives liquid iron from a cupola furnace. It has been shown that to use the obtained system of equations, it is necessary to know the initial carbon content in the melt discharged from the cupola furnace, and it depends on the method of oxygen supply to the cupola furnace. Based on the modeling of this process in two variants – using a “sharp blow” and supplying oxygen to the air blown into the tuyeres, a nomogram has been constructed. It allows to determine the initial carbon content for the practical use of the obtained system of equations. Using the obtained system makes it possible to determine the time after which oxygen cutoff should be made. This will allow to decide to implement software control of the melt blowing process in the converter. The presented study will be useful for machine-building enterprises that have foundry shops in their structure, where cast iron is smelted for the manufacture of castings.Keywords
This publication has 21 references indexed in Scilit:
- Effect of oxygen blowing on the competitive removal rate of silicon and iron from molten copperJournal of Materials Research and Technology, 2023
- The production of pig iron from crushing plant waste using hot blast cupolaAlexandria Engineering Journal, 2018
- Studies of a Quenched CupolaInternational Journal of Metalcasting, 2014
- Computer-integrated electric-arc melting process control systemEastern-European Journal of Enterprise Technologies, 2014
- Mathematical description typification in the problems of synthesis of optimal controller of foundry technological parametersEastern-European Journal of Enterprise Technologies, 2014
- Adaptive modeling in problems of optimal control search termovremennoy cast ironEastern-European Journal of Enterprise Technologies, 2013
- Mathematical modeling of the argon oxygen decarburization converter exhaust gas system at the reduction stageApplied Mathematical Modelling, 2005
- Field programmable gate arrays implementation of automated sensor self-validation system for cupola furnacesComputers & Industrial Engineering, 2004
- A technical note cupola efficiency improvement by increasing air blast temperatureJournal of Materials Processing Technology, 2002
- Experimental control of a cupola furnace1998