Influences of the Rolling Parameters on Multi-Material Copper-Aluminum Composites via Compound Casting
Open Access
- 15 April 2026
- journal article
- Published by Trans Tech Publications, Ltd. in Materials Science Forum
- Vol. 1185, 55-68
Abstract
Multi-material components that consist of copper and aluminum enable the combination of advantageous mechanical, thermal, and electrical properties at competitive cost. While roll bonding is an efficient-solid state joining technique, its implementation requires fully processed, cold-rolled strip material from two process routes. Continuous compound casting in contrast offers a more efficient approach by combining aluminum and copper during casting, followed by flat rolling in a single process route. However, the differences in flow stress between the metals can cause non-uniform elongation and therefore significant shear stresses at the interface during rolling. These stresses may lead to a delamination of the compound if process conditions are not well controlled. This study investigates whether a geometrically structured interface, introduced during compound casting, can contribute to withstanding interfacial shear stresses through mechanical interlocking. In finite element simulations varying process parameters including height reduction, initial temperature, rolling speed ratio, and pass schedule were examined. Results show that a structured interface can effectively resist shear stresses at the copper-aluminum boundary, thereby improving joint stability during deformation. Furthermore, the strain distribution as well as the fluctuation of the shear stresses can be controlled by the process parameters. The findings indicate that the mechanical interlocking by a geometric interface combined with optimized process parameters can enhance the rolling of compound-cast copper-aluminum composites.Keywords
This publication has 23 references indexed in Scilit:
- The adaption, evaluation and application of a semi-empirical bond strength model for the simulations of multi-pass hot roll bonding of aluminium alloysInternational Journal of Material Forming, 2023
- Vertical continuous compound casting of copper aluminum bilayer rodsJournal of Materials Processing Technology, 2021
- Effects of annealing temperature on the interfacial microstructure and bonding strength of Cu/Al clad sheets produced by twin-roll casting and rollingJournal of Materials Processing Technology, 2020
- Effects of asymmetry and annealing on interfacial microstructure and mechanical properties of Cu/Al laminated composite fabricated by asymmetrical roll bondingJournal of Alloys and Compounds, 2020
- Effect of heat treatment on bonding mechanism and mechanical properties of high strength Cu/Al/Cu clad compositeJournal of Alloys and Compounds, 2019
- Flow stress, mechanical and physical properties of electrolytic-tough-pitch copper (Cu-ETP)2016
- Influence of heat treatment on interface of Cu/Al bimetal composite fabricated by cold rollingComposites Part B: Engineering, 2011
- Al 99.52011
- Effects of processing parameters on the bond strength of Cu/Cu roll-bonded stripsJournal of Materials Processing Technology, 2010
- Steel symbol/number: X40CrMoV5–1/1.23442009