Variable-Gain Decentralized Input Voltage Sharing for ISOP DC–DC Converters
- 26 September 2025
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Power Electronics
- Vol. 41 (2) , 1579-1584
Abstract
It is a critical challenge in modular input-series–output-parallel (ISOP) conversion systems without input voltage monitor and interconnected lines to achieve balanced input voltage sharing (IVS) and output voltage regulation (OVR) under wide load variation. A novel variable-gain decentralized inverse-droop control method supporting full modularity design is proposed to address this issue in this letter. By designing the inverse-droop gain as a function of each converter module’s average inductor current, the proposed method can eliminate the requirements for input voltage sampling, high-voltage galvanic isolation of control circuits, and interconnected lines, which are very essential for ISOP converter modularity design. Furthermore, it can effectively extend the operation area with excellent IVS performance, while the OVR of the ISOP converter can also be effectively guaranteed. The principle of the proposed method is elaborated, and the small-signal-based stability analysis for the IVS control system along with the output voltage control system design of the ISOP converter is also investigated. The experimental results validate the effectiveness of the proposed control method.Keywords
Funding Information
- National Natural Science Foundation of China (52401402)
- Fundamental Research Funds for the Central Universities (3072024XX2712)
- National Natural Science Foundation of China (U24B2090)
- National Key Research and Development Program of China (2024YFB4710803)
This publication has 11 references indexed in Scilit:
- Multiloop Stability Analysis of Input Voltage Balancing Control in Dual-Active-Bridge-Based Input-Series Output-Parallel ConvertersIEEE Transactions on Power Electronics, 2025
- A 10 kV/400 V SiC Based DC-DC Converter With Input-Series-Output-Parallel Configuration and Three-Loop ControlIEEE Transactions on Industry Applications, 2024
- Stability Analysis and Design of Common Phase Shift Control for Input-Series Output-Parallel Dual Active Bridge With Consideration of Dead-Time EffectIEEE Journal of Emerging and Selected Topics in Power Electronics, 2022
- An Input-Voltage-Sharing Control Strategy of Input-Series-Output-Parallel Isolated Bidirectional DC/DC Converter for DC Distribution NetworkIEEE Transactions on Power Electronics, 2021
- Decentralized Inverse-Droop Control for Input-Series–Output-Parallel DC–DC ConvertersIEEE Transactions on Power Electronics, 2015
- Wireless Input-Voltage-Sharing Control Strategy for Input-Series Output-Parallel (ISOP) System Based on Positive Output-Voltage Gradient MethodIEEE Transactions on Industrial Electronics, 2014
- Common-Duty-Ratio Control of Input-Series Output-Parallel Connected Phase-shift Full-Bridge DC–DC Converter ModulesIEEE Transactions on Power Electronics, 2011
- Control Strategy for Input-Series–Output-Parallel ConvertersIEEE Transactions on Industrial Electronics, 2008
- Fault Tolerant Circuit Topology and Control Method for Input-Series and Output-Parallel Modular DC-DC ConvertersIEEE Transactions on Power Electronics, 2008
- Common-duty-ratio control of input-series connected modular DC-DC converters with active input voltage and load-current sharingIEEE Transactions on Industry Applications, 2006