Effect of Sanding and Plasma Treatment of 3D-Printed Parts on Bonding to Wood with PVAc Adhesive
Open Access
Abstract
Additive manufacturing is becoming increasingly important for manufacturing end products, not just prototyping. However, the size of 3D-printed products is limited due to available printer sizes and other technological limitations. For example, making furniture from 3D-printed parts and wooden elements requires adequate adhesive joints. Since materials for 3D printing usually do not bond very well with adhesives designed for woodworking, they require special surface preparation to improve adhesion. In this study, fused deposition modelling (FDM) 3D-printed parts made of polylactic acid (PLA), polylactic acid with wood flour additive (Wood-PLA), and acrylonitrile-butadiene-styrene (ABS) polymers were bonded to wood with polyvinyl acetate (PVAc) adhesive. The surfaces of the samples were bonded as either non-treated, sanded, plasma treated, or sanded and plasma treated to evaluate the effect of each surface preparation on the bondability of the 3D-printed surfaces. Different surface preparations affected the bond shear strength in different ways. The plasma treatment significantly reduced water contact angles on all tested printing materials and increased the bond tensile shear strength of the adhesive used. The increase in bond strength was highest for the surfaces that had been both sanded and plasma treated. The highest increase was found for the ABS material (untreated 0.05 MPa; sanded and plasma treated 4.83 MPa) followed by Wood-PLA (from 0.45 MPa to 3.96 MPa) and PLA (from 0.55 MPa to 3.72 MPa). Analysis with a scanning electron microscope showed the smooth surfaces of the 3D-printed parts, which became rougher with sanding with more protruded particles, but plasma treatment partially melted the surface structures on the thermoplastic polymer surfaces.Keywords
This publication has 60 references indexed in Scilit:
- Thermal, mechanical and tribological properties of polycarbonate/acrylonitrile-butadiene-styrene blendsJournal of Polymer Engineering, 2013
- Effect of Ammonia Plasma Treatment on the Properties and Cytocompatibility of a Poly(L-Lactic Acid) Film SurfaceJournal of Biomaterials Science, Polymer Edition, 2012
- Surface Modification of Biodegradable Poly(D,L-lactic acid) by Nitrogen and Nitrogen/Hydrogen Plasma for Improving Surface HydrophilicityPlasma Science and Technology, 2011
- Plasma surface treatments of poly(l-lactic acid) (PLLA) and poly(hydroxybutyrate-co-hydroxyvalerate) (PHBV)Materials Science and Engineering: C, 2009
- Immobilization of chitosan onto poly-l-lactic acid film surface by plasma graft polymerization to control the morphology of fibroblast and liver cellsBiomaterials, 2004
- Wetting on Hydrophobic Rough Surfaces: To Be Heterogeneous or Not To Be?Langmuir, 2003
- Improving cell affinity of poly(D,L‐lactide) film modified by anhydrous ammonia plasma treatmentPolymers for Advanced Technologies, 2002
- Effect of surface roughness on the strength of cleavage jointsInternational Journal of Adhesion and Adhesives, 2002
- Dynamic Wettability of Different Machined Wood SurfacesThe Journal of Adhesion, 2001
- Interactions of Electroless Catalysts with Plasma‐Oxidized Surfaces of Polystyrene‐Based ResinsJournal of the Electrochemical Society, 1989