A New Control Scheme for the Buck Converter
Open Access
- 3 February 2023
- journal article
- research article
- Published by MDPI AG in Applied Sciences
- Vol. 13 (3) , 1991
Abstract
In this paper, a new control scheme for buck converters was proposed. The buck converter utilizes the dual control loop to improve transient response and has the constant switching frequency. The control scheme is mainly as follows: (a) The switch-ON time is regulated by the constant frequency mechanism. (b) The switch-OFF time is regulated by the output voltage. The spec/features of the proposed converter are listed as: (1) The buck converter has an output of 1.0–2.5 V for the input of 3.0–3.6 V. The load current ranges from 100 mA to 500 mA. (2) The actual current sensor is not required. (3) The simulation results show that the recovery time is less than 1.6 μs during load changes. (4) The variation in switching frequency is smaller than 1.05% over the output range of 1.0–2.5 V. (5) This circuit can be fabricated in future by UMC 0.18 μm 1P6M CMOS processes. This paper depicts the control scheme, theoretical analysis, and implementation.Keywords
This publication has 28 references indexed in Scilit:
- A 30-MHz Voltage-Mode Buck Converter Using Delay-Line-Based PWM ControlIEEE Transactions on Circuits and Systems II: Express Briefs, 2017
- A New Fast Adaptive On-Time Control for Transient Response Improvement in Constant On-Time ControlIEEE Transactions on Power Electronics, 2017
- A Novel Adaptive Quasi-Constant On-Time Current-Mode Buck ConverterIEEE Transactions on Power Electronics, 2016
- Average current-mode control of buck dc-dc converter with reduced control voltage ripple2016
- Designing a Dynamic Ramp With an Invariant Inductor in Current-Mode Control for an On-Chip Buck ConverterIEEE Transactions on Power Electronics, 2014
- Soft switched flyback converter for SMPS applications2013
- Analysis of bi-directional buck-boost converter for energy storage applications2013
- Sub-1-V Fast-Response Hysteresis-Controlled CMOS Buck Converter Using Adaptive Ramp TechniquesIEEE Transactions on Very Large Scale Integration (VLSI) Systems, 2012
- Two-Stage Isolated Switch-Mode Power Supply With High Efficiency and High Input Power FactorIEEE Transactions on Industrial Electronics, 2010
- Analysis and Optimization of Switched-Capacitor DC–DC ConvertersIEEE Transactions on Power Electronics, 2008