XYXuan Yang

Xuan Yang

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Xuan Yang has a total of 5 co-authors. Here are the top co-authors by number of shared publications:

  • Hsiao-Hsing Chou

    Department of Computer Science and Information Engineering, National Taichung University of Science and Technology, Taichung, Taiwan

    1 shared publication
  • Jian-Yu Chen

    Department of Communication Engineering, National Penghu University of Science and Technology, Penghu, Magong City 880011, Taiwan

    1 shared publication
  • Jun-Yi Yang

    Department of Communication Engineering, National Penghu University of Science and Technology, Penghu, Magong City 880011, Taiwan

    1 shared publication
  • San-Fu Wang

    National Chin-Yi University of Technology College of Electrical Engineering and Computer Science Taichung and Department of Electronic Engineering, National Chin-Yi University of Technology, Taichung, Taiwan

    1 shared publication
  • Tsung-Hu Tseng

    Department of Communication Engineering, National Penghu University of Science and Technology, Penghu, Magong City 880011, Taiwan

    1 shared publication

Latest Publications

  • Open Access

    A New Control Scheme for the Buck Converter

    by Hsiao-Hsing Chou, Jian-Yu Chen, Tsung-Hu Tseng, Jun-Yi Yang, Xuan Yang, San-Fu Wang

    In this paper, a new control scheme for buck converters was proposed. The buck converter utilizes the dual control loop to improve transient response and has the constant switching frequency. The control scheme is mainly as follows: (a) The switch-ON time is regulated by the constant frequency mechanism. (b) The switch-OFF time is regulated by the output voltage. The spec/features of the proposed converter are listed as: (1) The buck converter has an output of 1.0–2.5 V for the input of 3.0–3.6 V. The load current ranges from 100 mA to 500 mA. (2) The actual current sensor is not required. (3) The simulation results show that the recovery time is less than 1.6 μs during load changes. (4) The variation in switching frequency is smaller than 1.05% over the output range of 1.0–2.5 V. (5) This circuit can be fabricated in future by UMC 0.18 μm 1P6M CMOS processes. This paper depicts the control scheme, theoretical analysis, and implementation.