Skin-Friction Coefficient Model Verification and Flow Characteristics Analysis in Disk-Type Gap for Radial Turbomachinery
Open Access
- 15 September 2023
- journal article
- research article
- Published by MDPI AG in Applied Sciences
- Vol. 13 (18) , 10354
Abstract
Under the conditions of high speed and density flow, the windage loss in the gap behind an impeller has an important influence on its thermal power conversion efficiency. Daily and Nece took the relative gap and Reynolds number as the characteristic parameters and divided the flow of a rotating disk in a closed chamber into four flow regions through laminar flow, turbulent flow and state of boundary layers. In this paper, the skin-friction coefficient model of Regio III and IV was verified by a numerical method under conditions corresponding to the typical Reynolds number range for a radial impeller. The results show that when the relative gap increases, the relative deviation between the numerical calculation and the model prediction results decreases, and the maximum deviation is −12.4%. With the increase of Reynolds number, the Region IV model is more accurate. Region III has the flow state of boundary layers merging and separation at the same time. Both models have good prediction accuracy with different mediums of air, water-liquid and critical CO2. The deviation in Region III is larger and shows a decreasing trend with respect to Region IV, Based on the two models, a method for predicting the optimal gap is proposed. The method is verified to be reliable and can minimize windage loss.Keywords
Funding Information
- National Natural Science Foundation of China (U20A20303, 2017YFB0601804)
- National Key Research and Development Program of China (U20A20303, 2017YFB0601804)
This publication has 17 references indexed in Scilit:
- Supercritical carbon dioxide cycles for power generation: A reviewApplied Energy, 2017
- Numerical investigation on the flow and heat transfer in a rotor-stator disc cavityApplied Thermal Engineering, 2015
- Investigation of the fluid flow in an isolated rotor-stator system with a peripheral openingScience China Physics, Mechanics & Astronomy, 2013
- Use of CFD Analyses to Predict Disk Friction Loss of Centrifugal Compressor ImpellersTRANSACTIONS OF THE JAPAN SOCIETY FOR AERONAUTICAL AND SPACE SCIENCES, 2012
- Procedure for Estimation and Reporting of Uncertainty Due to Discretization in CFD ApplicationsJournal of Fluids Engineering, 2008
- Investigations on fluid friction of rotational disks with and without modified outlet sections in real centrifugal pump casingsForschung im Ingenieurwesen, 2007
- Disk friction losses of closed turbomachine impellersForschung im Ingenieurwesen, 2003
- An optimum set of loss models for performance prediction of centrifugal compressorsProceedings of the Institution of Mechanical Engineers, Part A: Journal of Power and Energy, 1997
- Surface Roughness Effects on Induced Flow and Frictional Resistance of Enclosed Rotating DisksJournal of Fluids Engineering, 1995
- An Approximate Solution for the Flow Between a Rotating and a Stationary DiskJournal of Turbomachinery, 1989