A 15-MHz, 2.7-mm 2 Notch-Free Hybrid Magnetic Current Sensor With Feedforward Ripple Cancellation and ±0.8% Local Gain Non-Uniformity
- 19 May 2026
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Solid-State Circuits
- Vol. PP (00189200) , 1-13
Abstract
This article proposes a hybrid magnetic current sensor achieving a 15-MHz bandwidth within a compact 2.7-mm2 area. To mitigate the pole–zero mismatch inherent in the two-stage integrator topology, a dual-output Gm-C integrator with subtractor-based compensation is proposed, achieving a ±0.8% local gain non-uniformity. A wideband feedforward ripple suppression scheme cancels chopping ripple without bandwidth degradation, achieving 25-dB suppression while avoiding in-band notches common in ripple reduction loop (RRL) schemes. In addition, two active capacitor-boosting techniques enhance the effective capacitance in the DC servo loop (DCSL) and the differential difference amplifier (DDA), realizing significant passive area savings. While the Hall sensitivity drift is compensated by bias current with a positive temperature coefficient (PTC), a negative-temperature-coefficient (NTC) ground technique is proposed to stabilize the Hall-plate common-mode (CM) output. Compared with the state of the art, the proposed sensor achieves $3\times $ higher bandwidth, $1.5\times $ improved gain flatness, and 30% smaller chip area.Keywords
Funding Information
- National Natural Science Foundation of China (62174030)
- National Natural Science Foundation of China (BK20244005)
This publication has 48 references indexed in Scilit:
- Design, Implementation, and Comparison of Multi-MHz Multi-kW H-Bridge Inverters Based on 650V SiC and GaN Devices for High-Frequency WPT2024
- An Integrated and Galvanically Isolated DC-to-15.3 MHz Hybrid Current Sensor2019
- A fully integrated DC to 75 MHz current sensing circuit with on-chip Rogowski coil2018
- An improved Rogowski coil configuration for a high speed, compact current sensor with high immunity to voltage transients2018
- GaN-based high efficiency bidirectional DC-DC converter with 10 MHz switching frequency2017
- 27.9 A 200kS/s 13.5b integrated-fluxgate differential-magnetic-to-digital converter with an oversampling compensation loop for contactless current sensing2015
- A miniature digital current sensor with differential Hall probes using enhanced chopping techniques and mechanical stress compensation2012
- A low power 16-channel fully integrated GMR-based current sensor2012
- Circuit techniques for reducing the effects of op-amp imperfections: autozeroing, correlated double sampling, and chopper stabilizationProceedings of the IEEE, 1996
- A low-offset spinning-current hall plateSensors and Actuators A: Physical, 1990