Microstructural properties of ordinary concrete mixed with rubber and plastic waste under aggressive environmental conditions: A full‐factorial design study
- 6 November 2026
- journal article
- Published by Wiley in Structural Concrete
Abstract
The aim of this study was to incorporate the waste plastic and rubber into concrete in order to manufacture concrete that is resistant to aggressive environments, using the factorial approach to assess the effect of different factors (rubber and plastic) on the selected responses. In this research, ordinary Portland cement and fine aggregate were partially replaced with rubber and plastic as a mass substitute in the proportions of 2% and 4% and the fine aggregate 2%, 4%, and 6%, respectively. The tests used for the fresh properties were workability and density, whereas the hardened properties were assessed using compressive strength, flexural strength, and weight loss, as well as micro‐structural analysis, XRD, and scanning electron microscopy, SEM. The results show a decrease in workability, density, compressive strength, flexural strength, and weight loss when increasing the percentage of plastic and rubber used. The workability decreases from 80 to 20 mm, and the density decreases from 2.38 to 2.20 kg/m 3 ; the compressive and flexural strengths, respectively, decreased by up to 38% and 20.5% at 28 days compared to the control concrete. Moreover, the weight loss decreases by up to 25% compared to the control concrete. In addition, SEM indicated that the voids are filled with the waste rubber and plastic and thus reduce the penetration of sulfuric acid into the concrete. This helps maintain the integrity and durability of concrete in the face of aggressive environments. The test findings were subjected to analyses of variance in order to determine the significance of the influence factors and their interactions on the chosen responses. The results show that the coefficient R 2 ranges between 0.89 and 0.99, which indicates a good correlation between the predicted and experimental modes.Keywords
This publication has 58 references indexed in Scilit:
- Effect of Crumb Rubber on Concrete’s and Mortar’s Structural Properties: A ReviewIranian Journal of Science and Technology, Transactions of Civil Engineering, 2024
- Evaluation of the effect of E-waste on the permeability properties of polymer concrete composites and their behavior in aggressive environmentsArchives of Civil and Mechanical Engineering, 2024
- Utilization of plastic waste as replacement of natural aggregates in sustainable concrete: effects on mechanical and durability propertiesInternational Journal of Environmental Science and Technology, 2023
- Upcycling of waste polyethylene and cement kiln dust to produce polymeric composite sheets using gamma irradiationPolymer Bulletin, 2022
- Assessment of Mechanical and Impact Resistance Properties of Rubberized Concrete After Surface Modification of Rubber CrumbIranian Journal of Science and Technology, Transactions of Civil Engineering, 2021
- Investigating mechanical properties and durability of concrete containing recycled rubber ash and fibersJournal of Material Cycles and Waste Management, 2021
- Factorial Design2014
- Strength and Durability of Mortar Made with Plastics Bag Waste (MPBW)International Journal of Concrete Structures and Materials, 2012
- Improvement of chloride ion penetration resistance in cement mortars modified with rubber from worn automobile tiresCement and Concrete Composites, 2009
- Properties of tire rubber ash mortarCement and Concrete Composites, 2004