On the Microstructural and Tribological Investigations of WC-12Co/NiCrFeSiAlBC HVOF Cermet Coatings: Effects of WC-12Co Fraction
Open Access
- 26 February 2026
- journal article
- research article
- Published by MDPI AG in Lubricants
- Vol. 14 (3) , 100
Abstract
Previous research indicates that WC-12Co contents above 60 wt.% in feedstock powders for cermet coatings impair adhesion and wear resistance. This study characterizes NiCrFeSiAlBC coatings—unreinforced or reinforced with 65 wt.% or 85 wt.% WC-12Co—applied via high-velocity oxy-fuel (HVOF) spraying onto stainless steel substrates under controlled parameters. It quantifies the influence of high carbide volume fractions within the NiCrFeSiAlBC matrix on microstructure and tribomechanical performance. Microstructural analysis revealed uniformly distributed cermet layers featuring dissolved reinforcements and WC hard phase formation, with minimal W2C crystallization. Elevated WC-12Co incorporation promoted densification and reduced porosity. Vickers microhardness tests (HV 0.3) demonstrated increased hardness upon WC-12Co addition, attributable to finer particle sizes, lower porosity, and the presence of WC phases alongside crystallographic refinements. Under dry reciprocating sliding conditions, friction coefficients and wear volumes decreased markedly. Consequently, the coating with 85 wt.% WC exhibited the best mechanical and tribological properties.Keywords
Funding Information
- AM2R—Agenda Mobilizadora para a inovação empresarial do setor das Duas Rodas (C644866475-00000012)
- PRR—Recovery and Resilience Plan under the Next Generation EU from the European Union
- Centre for Mechanical Technology and Automation
This publication has 38 references indexed in Scilit:
- The influence of ball milling conditions on the powder characteristics and sintering densification of Mo Cu alloyInternational Journal of Refractory Metals and Hard Materials, 2024
- Microstructural analysis of flame-sprayed and PTA-deposited nickel-based self-fluxing alloy coatingsWelding in the World, 2024
- Improving WC-Co coating adhesive strength on rough substrate: Finite element modeling and experimentJournal of Materials Science & Technology, 2020
- Effect of Fe Intermetallics on Microstructure and Properties of Al-7Si AlloysJOM, 2019
- An Investigation on the Wear and Corrosion Behavior of HVOF-Sprayed WC-12Co-Al2O3 Cermet CoatingJournal of Materials Engineering and Performance, 2018
- Multiscale ab initio simulation of Ni-based alloys: Real-space distribution of atoms in γ + γ ′ phaseComputational Materials Science, 2015
- Application of hardmetals as thermal spray coatingsInternational Journal of Refractory Metals and Hard Materials, 2015
- Comparison of corrosion behaviour of thermal sprayed and diffusion-coated materialsMaterials and Corrosion, 2002
- Four-point bending tests of thermally produced WC-Co coatingsSurface and Coatings Technology, 1996
- Alloying and post-heat-treatment of thermal-sprayed coatings of self-fluxing alloysSurface and Coatings Technology, 1993