Fault tolerant control for DFIG wind turbine controlled by ADRC and optimized by genetic algorithm
Open Access
- 1 September 2023
- journal article
- research article
- Published by Institute of Advanced Engineering and Science in International Journal of Power Electronics and Drive Systems (IJPEDS)
- Vol. 14 (3) , 1382-1393
Abstract
This research work deals with the modelling, control and simulation of a wind turbine based on the doubly fed induction generator (DFIG) in the current sensor’s failure event. We present in the first time the model of the wind energy conversion system based on the DFIG and the control by active disturbances rejection control (ADRC) optimized by genetic algorithm. Particular focus is directed towards on a technique for detection, identification, isolation and reconfiguration of current sensor signals after failure. The combination of the two preceding techniques makes it possible to have a fault tolerant control to sensor faults which ensures continuity of service in all circumstances. The robustness of the proposed technique is tested under the MATLAB/Simulink environment.Keywords
This publication has 23 references indexed in Scilit:
- Participation of a DFIG Based Wind Energy Conversion System in Frequency Control2020
- Efficient real-time estimation for DFIG—Performance and reliability enhancement of grid/micro-grid connected energy conversion systemsJournal of Renewable and Sustainable Energy, 2019
- Power control of variable speed wind turbine based on doubly fed induction generator using indirect field‐oriented control with fuzzy logic controllers for performance optimizationEnergy Science & Engineering, 2018
- Power Control of a DFIG Driving by Wind Turbine: Comparison Study Between ADRC and PI Controller2017
- Study of the PI Controler and Sliding Mode of DFIG used in a WECS2017
- Fault detection and isolation based on nonlinear analytical redundancy applied to an induction machine2017
- Contributions to diagnosis and fault tolerant control based on Proportional Integral Observer: Application to a doubly-fed induction generator2015
- Maximization of generated power from wind energy conversion systems using a doubly fed induction generator with active disturbance rejection control2014
- Design and implementation of STATCOM combined with series dynamic breaking resistor for low voltage ride-through of wind farms2010
- Doubly Fed Induction Generator Model-Based Sensor Fault Detection and Control Loop ReconfigurationIEEE Transactions on Industrial Electronics, 2009