Ikram Aissaoui
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Ikram Aissaoui has a total of 3 co-authors. Here are the top co-authors by number of shared publications:
- Ahmed Essadki
Mohammed V University-Rabat-Morocco,ERERA, Research Center in Sciences and Technologies of Engineering and Health (STIS). Higher Normal School of Technical Education (ENSET)
1 shared publication - Hind Elaimani
Institut Supérieur d’Ingénierie et des Affaires (ISGA Rabat)
1 shared publication - Noureddine Elmouhi
Institut Supérieur d’Ingénierie et des Affaires (ISGA Rabat)
1 shared publication
Latest Publications
- Open Access
- 1 September 2023
- Published by Institute of Advanced Engineering and Science in International Journal of Power Electronics and Drive Systems (IJPEDS)
- Vol. 14 (3) , 1382-1393
Fault tolerant control for DFIG wind turbine controlled by ADRC and optimized by genetic algorithm
This research work deals with the modelling, control and simulation of a wind turbine based on the doubly fed induction generator (DFIG) in the current sensor’s failure event. We present in the first time the model of the wind energy conversion system based on the DFIG and the control by active disturbances rejection control (ADRC) optimized by genetic algorithm. Particular focus is directed towards on a technique for detection, identification, isolation and reconfiguration of current sensor signals after failure. The combination of the two preceding techniques makes it possible to have a fault tolerant control to sensor faults which ensures continuity of service in all circumstances. The robustness of the proposed technique is tested under the MATLAB/Simulink environment.
- 1 September 2023
- Published by Institute of Advanced Engineering and Science in International Journal of Power Electronics and Drive Systems (IJPEDS)
- Vol. 14 (3) , 1382-1393
Open AccessFault tolerant control for DFIG wind turbine controlled by ADRC and optimized by genetic algorithm
This research work deals with the modelling, control and simulation of a wind turbine based on the doubly fed induction generator (DFIG) in the current sensor’s failure event. We present in the first time the model of the wind energy conversion system based on the DFIG and the control by active disturbances rejection control (ADRC) optimized by genetic algorithm. Particular focus is directed towards on a technique for detection, identification, isolation and reconfiguration of current sensor signals after failure. The combination of the two preceding techniques makes it possible to have a fault tolerant control to sensor faults which ensures continuity of service in all circumstances. The robustness of the proposed technique is tested under the MATLAB/Simulink environment.