Cylinder liner deformation orders and efficiency of a piston ring-pack
Open Access
- 13 May 2019
- conference paper
- Published by EDP Sciences in E3S Web of Conferences
- Vol. 95, 04001
Abstract
One of the several losses of a combustion chamber is the gas leakage toward the crankcase due to imperfect sealing of the rings. It is commonly known as blow by and it affects efficiency and emissions. The paper initially describes a bibliographic review of the phenomenon, together with the equations of the system. A typical piston ring pack for internal combustion engine is proposed to be analysed and solved using ©Ricardo RINGPAK Solver. A specific issue such as Bore distortion orders were used to investigate the sealing capacity of the ring-pack in terms of ring dynamics, inter-ring pressures and mass flows. Bore distortion orders and their magnitude showed to affect the ring pack behavior. Order zero distortion resulted to be the most important order due to the highest amount of gas lost in the crankcase, while orders three and four resulted to generate high blow-by values, even if their magnitude of distortion is lower in comparison to other orders.Keywords
This publication has 15 references indexed in Scilit:
- An Experimental Study of the Time Scales and Controlling Factors Affecting Drastic Blow-by Increases during Transient Load Changes in SI EnginesSAE International Journal of Advances and Current Practices in Mobility, 2008
- Dynamic behaviours of piston rings and their practical impact. Part 1: Ring flutter and ring collapse and their effects on gas flow and oil transportProceedings of the Institution of Mechanical Engineers, Part J: Journal of Engineering Tribology, 2002
- Challenges Involved in Piston Top Ring Designs for Modern SI EnginesJournal of Engineering for Gas Turbines and Power, 2000
- Modeling Piston-Ring Dynamics, Blowby, and Ring-Twist EffectsJournal of Engineering for Gas Turbines and Power, 1998
- Comparison of Measured and Theoretical Inter-Ring Gas Pressure on a Diesel EngineSAE International Journal of Advances and Current Practices in Mobility, 1996
- The Effects of Cylinder Wall Surface Roughness and Bore Distortion on Blow-by in Automotive EnginesTribology Transactions, 1995
- An Integrated Model of Ring Pack PerformanceJournal of Engineering for Gas Turbines and Power, 1991
- Analysis of Distortions of Cylinders and Conformability of Piston RingsTribology Transactions, 1990
- On the Flow of Gas Through the Piston-Rings : 2nd Report, The Character of Gas LeakageBulletin of JSME, 1961
- Piston Ring Movement during Blow-by in High-Speed Petrol EnginesProceedings of the Institution of Mechanical Engineers: Automobile Division, 1947