Microstructural Evolution of Pearlitic Wheel Steel Under Thermal–Mechanical Fatigue
Open Access
Abstract
Pearlitic wheel steel subjected to thermal–mechanical fatigue (TMF) during braking can undergo catastrophic fracture. This study clarifies the microstructural evolution governing the macroscopic cyclic hardening/softening behavior of pearlitic wheel steel under thermal–mechanical fatigue (TMF) with a constant mechanical strain range of −0.4% to +0.2%. At lower temperature amplitudes (200–500 °C), the geometrically necessary dislocation (GND) density reaches 20.4 × 1014/m2 during initial cycles, corresponding to cyclic hardening due to dislocation pile-ups at cementite lamellae interfaces. With increasing cycles, the GND density decreases to 12.3 × 1014/m2, concurrent with softening arising from lamellar bending/fracture, partial spheroidization, and dynamic recrystallization of ferrite. At higher temperature amplitudes (200–730 °C), the GND density decreases from 8.8 × 1014/m2 to 3.5 × 1014/m2, reflecting sustained cyclic softening dominated by thermally activated mechanisms, including cementite spheroidization and dislocation annihilation. The resulting softened microstructure consists of ferrite grains, intragranular dispersed cementite, and chain-like coarse cementite at boundaries. Unlike previous studies that focused on single loading conditions (e.g., thermal fatigue, rolling contact fatigue, or wear), the present work addresses the more complex TMF scenario and quantitatively elucidates the interplay between mechanical response and microstructural evolution in pearlitic steel. This work provides theoretical guidance for the development of a fatigue life prediction model for pearlitic wheels under braking.Keywords
Funding Information
- Advanced Materials-National Science and Technology Major Project of China (2025ZD0610800)
- China National Railway Group Science and Technology Program (Q2024J013)
- Research Project of China Academy of Railway Sciences Corporation Limited (2025YJ004)
This publication has 29 references indexed in Scilit:
- Numerical thermo-mechanical modeling of tread braking systems under ultra-long downhill constant-speed conditions with coupled time-dependent heat partition coefficientsInternational Communications in Heat and Mass Transfer, 2025
- A microstructure-based constitutive model for eutectoid steelsActa Materialia, 2023
- Microstructure stability in wheel steel: A case of thermal-accumulated damage capacity in pearlite and low-carbon bainiteEngineering Failure Analysis, 2023
- Modelling of temperature and strain rate dependent behaviour of pearlitic steel in block braked railway wheelsRailway Engineering Science, 2021
- Effect of temperature range on thermal-mechanical fatigue properties of P92 steel and fatigue life prediction with a new cyclic softening modelInternational Journal of Fatigue, 2019
- Role of microstructure and crystallographic orientation in fatigue crack failure analysis of a heavy haul railway railEngineering Failure Analysis, 2019
- Mechanisms of pearlite spheroidization: Insights from 3D phase-field simulationsActa Materialia, 2018
- Thermal–mechanical fatigue behaviour of a new single crystal superalloy: Effects of Si and Re alloyingActa Materialia, 2015
- Quantitative measurements of dynamic precipitation during fatigue of an Al–Zn–Mg–(Cu) alloy using small-angle X-ray scatteringActa Materialia, 2014
- Kinetics of flow and strain-hardeningActa Metallurgica, 1981