Influence of Tool Traverse Speed on Microstructural Characteristics and Mechanical Properties of Friction Stir Processed AA5754 Aluminium Alloy Under Overlap Configuration
Open Access
- 19 March 2026
- journal article
- Published by IOP Publishing in Materials Research Express
- Vol. 13 (7)
Abstract
AA5754-H111, a non-heat-treatable aluminium alloy of the 5000 series, is widely used in automotive and marine structures owing to its good strength-to-weight ratio, with strength enhancement achieved through strain hardening. Friction Stir Processing (FSP), derived from the Friction Stir Welding (FSW) technique, is increasingly applied to refine microstructures in the stir zone under solid-state conditions, thereby avoiding solidification-related defects. The effectiveness of FSP depends largely on three process parameters: tool rotational speed, tool traverse speed, and tool tilt angle. Although considerable work has been conducted on these parameters for aluminium alloys, the influence of tool traverse speed on AA5754 under overlap configuration has not been reported. In this study, two overlapped AA5754 plates (6 mm each) were processed using a tapered threaded HSS tool at three different traverse speeds (10, 15, and 20 mm/min), with other parameters kept constant. Post-FSP, the stir zone was examined through optical microscopy and XRD analysis, and tensile properties were evaluated. Results revealed that a traverse speed of 15 mm/min produced a defect-free stir zone and delivered the highest tensile properties, with an ultimate tensile strength of 232 MPa, yield strength of 192 MPa, and elongation of 37%, compared to the base metal values of 181 MPa, 167 MPa, and 14%, respectively. From the micro-structural evaluation, it is observed that the formation of a fine, equiaxed dynamically recrystallized grain structure in the stir zone, along with reduced grain size and homogeneous microstructural distribution as compared to the base material. The findings confirm that tool traverse speed critically controls heat generation and thereby governs microstructural refinement and mechanical performance of AA5754 alloy joints.Keywords
This publication has 32 references indexed in Scilit:
- Influence of cryogenic treatment on mechanical and ballistic properties of AA5754 alloy friction stir welded jointsDefence Technology, 2025
- Impact of Differential Cooling Rates on Wire Arc Additive Manufactured HSLA Steel ComponentMetallography, Microstructure, and Analysis, 2024
- Mechanical and Metallurgical Characteristics of Wire-Arc Additive Manufactured HSLA Steel Component Using Cold Metal Transfer TechniqueAdditive Manufacturing Frontiers, 2024
- Effect of underwater friction stir welding parameters on AA5754 alloy joints: experimental studiesThe International Journal of Advanced Manufacturing Technology, 2024
- Multi-objective optimization of FSW variables on joint properties of AA5754 aluminum alloy using Taguchi approach and grey relational analysisThe International Journal of Advanced Manufacturing Technology, 2024
- Effect of traverse speed on microstructure and mechanical properties of friction-stir-welded third-generation Al–Li alloyJournal of the Brazilian Society of Mechanical Sciences and Engineering, 2020
- Friction stir process: a green fabrication technique for surface composites—a review paperSN Applied Sciences, 2020
- Aluminum alloys in marine construction: characteristics, application, and problems from a fabrication viewpointMarine Systems & Ocean Technology, 2019
- Friction stir processing – State of the artArchives of Civil and Mechanical Engineering, 2018
- Production by FSW of free-shape hollow box profile in AA5754 for automotive applicationWelding in the World, 2016