Abstract
WST has been keeping in the research and development of internal-tin (IT) Nb3Sn strand for higher performance level, for the future fusion reactor after ITER. Deformation optimization, Cu splits and Sn spacers were applied to prepare Nb3Sn strand with higher Jcn and lower hysteresis loss, and effect of these three factors on performance was investigated and discussed. Compared with the Nb3Sn strand for ITER, strand distortion was obviously reduced by deformation optimization and Jcn was improved, but at the same time hysteresis level was increased. To reduce the level of hysteresis loss, Cu splits were used to replace a few Nb filaments in each subelement. Cu splits could break the bridging Nb3Sn filament rings and as a sequence hysteresis loss was dramatically reduced along with the reduction of Jcn, which is attributed to low reaction degree of Nb filaments in the outermost subelements. Therefore, Sn spacers between the outermost subelements and the Ta barrier were added, and a 37-subelement structure was used to shorten the diffusion path of Sn. Reaction degree of the filaments was enhanced as well as Jcn. Finally, it could be concluded that 37-subelement structure with Cu splits is effective to reduce the level of hysteresis loss and raise the level of Jcn.
Funding Information
  • ITER Program (973 Program) (2014GB105003, 2015GB121002)
  • International Corporation Program of the Ministry of Science and Technology of the People's Republic of China (2015DFR50010)

This publication has 10 references indexed in Scilit: