Impact of Substrate Type and Membrane Scaling on Catalyst Transfer Efficiency in PEM Water Electrolyzers via the Decal Method
Open Access
- 1 January 2026
- journal article
- Published by Wiley in International Journal of Chemical Engineering
- Vol. 2026 (1) , 9945399
Abstract
Catalyst‐coated membranes (CCMs) were fabricated using the decal transfer method to enhance catalyst transfer efficiency, performance, and stability in polymer electrolyte membrane water electrolyzers (PEMWEs). Nafion 117 and Nafion 212 membranes with active 5, 25, and 36 cm 2 areas were used, incorporating IrO 2 (anode) and Pt/C (cathode) catalysts. Catalyst inks were sprayed onto PTFE sheet, Kapton film, and Teflon‐coated fiberglass substrates, followed by hot‐pressing at 130°C and 700 psi for 5 min. A thin Nafion ionomer layer facilitated efficient catalyst transfer. Among the substrates, Teflon‐coated fiberglass achieved the highest transfer efficiency (> 95%) and uniform catalyst distribution. At 60°C and 2.0 V, the 5 cm 2 Nafion 212 and Nafion 117 CCMs delivered maximum peak current densities of 1791 and 1497 mA/cm 2 , respectively. While Nafion 212 showed higher initial performance due to its lower thickness and resistance, Nafion 117 demonstrated superior durability during 48‐h stability testing, particularly at larger membrane sizes. These results underscore the potential of the decal method for scalable CCM fabrication and highlight the importance of membrane thickness and substrate selection in developing high‐performance, durable PEMWE systems for hydrogen production.Keywords
This publication has 37 references indexed in Scilit:
- Advancements in ordered membrane electrode assembly (MEA) for water electrolysisCurrent Opinion in Electrochemistry, 2024
- Effect of catalyst ink particle size on the structure of the catalyst layer and electrical performance in the process of ultrasonic spray manufacturing PEMFCsEnergy, 2024
- Comparison of catalyst-coated membranes and catalyst-coated substrate for PEMFC membrane electrode assembly: A reviewChinese Journal of Chemical Engineering, 2021
- Recent trend in thermal catalytic low temperature CO2 methanation: A critical reviewCatalysis Today, 2021
- Research progress of catalyst layer and interlayer interface structures in membrane electrode assembly (MEA) for proton exchange membrane fuel cell (PEMFC) systemeTransportation, 2020
- Initial approaches in benchmarking and round robin testing for proton exchange membrane water electrolyzersInternational Journal of Hydrogen Energy, 2019
- Development of a low temperature decal transfer method for the fabrication of proton exchange membrane fuel cellsInternational Journal of Hydrogen Energy, 2017
- A modified decal method for preparing the membrane electrode assembly of proton exchange membrane fuel cellsFuel, 2015
- An efficient decal transfer method using a roll-press to fabricate membrane electrode assemblies for direct methanol fuel cellsInternational Journal of Hydrogen Energy, 2012
- Development of a novel decal transfer process for fabrication of high-performance and reliable membrane electrode assemblies for PEMFCsInternational Journal of Hydrogen Energy, 2011