David Cordova
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
David Cordova has a total of 9 co-authors. Here are the top co-authors by number of shared publications:
- Sergio Bampi
Graduate Program in Microelectronics (PGMICRO), Universidade Federal do Rio Grande do Sul, Porto Alegre, Brazil
6 shared publications - Hamilton Klimach
Universidade Federal do Rio Grande do Sul image/svg+xml
5 shared publications - Pedro Toledo
Department of Electronics and Telecommunications (DET), Politecnico di Torino, Torino, Italy
4 shared publications - Arthur Campos de Oliveira
Microelectronics Graduate Program, Federal University of Rio Grande do Sul, Porto Alegre, Brazil
2 shared publications - Eric Fabris
NSCAD Microelectrônica
2 shared publications - Eric Fabris
Research and Development, CEITECS. A., Porto Alegre, Brazil
2 shared publications
Latest Publications
- 31 July 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Circuits and Systems II: Express Briefs
- Vol. 66 (10) , 1663-1667
A 0.3–1.2 V Schottky-Based CMOS ZTC Voltage Reference
A voltage reference based on MOSFETs operated under Zero Temperature Coefficient (ZTC) bias is proposed. The circuit operates in a power supply voltage range from 0.3V up to 1.2V and outputs three different reference voltages using Standard-VT (SVT), Low-VT (LVT), and Zero-VT (ZVT) MOS transistors biased near their ZTC point by a single PTAT current reference. Measurements on 15 circuit samples fabricated in a standard 0.13-μm CMOS process show a worst-case normalized standard deviation (σ/μ) of 3% (SVT), 5.1% (LVT) and 10.8% (ZVT) respectively with a 75% of confidence level. At the nominal supply voltage of 0.45 V, the measured effective temperature coefficients (TCeff) range from 140 to 200 ppm/∘C over the full commercial temperature range. At room temperature (25∘C), line sensitivity in the ZVT VR is just 1.3%/100mV, over the whole supply range. The proposed reference draws around 5 μW and occupies 0.014 mm2 of silicon area.
- 31 July 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Circuits and Systems II: Express Briefs
- Vol. 66 (10) , 1663-1667
A 0.3–1.2 V Schottky-Based CMOS ZTC Voltage Reference
A voltage reference based on MOSFETs operated under Zero Temperature Coefficient (ZTC) bias is proposed. The circuit operates in a power supply voltage range from 0.3V up to 1.2V and outputs three different reference voltages using Standard-VT (SVT), Low-VT (LVT), and Zero-VT (ZVT) MOS transistors biased near their ZTC point by a single PTAT current reference. Measurements on 15 circuit samples fabricated in a standard 0.13-μm CMOS process show a worst-case normalized standard deviation (σ/μ) of 3% (SVT), 5.1% (LVT) and 10.8% (ZVT) respectively with a 75% of confidence level. At the nominal supply voltage of 0.45 V, the measured effective temperature coefficients (TCeff) range from 140 to 200 ppm/∘C over the full commercial temperature range. At room temperature (25∘C), line sensitivity in the ZVT VR is just 1.3%/100mV, over the whole supply range. The proposed reference draws around 5 μW and occupies 0.014 mm2 of silicon area.
- 14 September 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Circuits and Systems I: Regular Papers
- Vol. 65 (11) , 3790-3799
A 0.12–0.4 V, Versatile 3-Transistor CMOS Voltage Reference for Ultra-Low Power Systems
In this paper, we propose an ultra-low power compact 3-transistor voltage reference capable of operating at ultra-low supply voltages. The proposed circuit is based on the self-cascode MOSFET (SCM), which provides a reference voltage proportional to the threshold voltage (VT) difference of the two NMOS transistors that compose it. Reverse short-channel and narrow-width effects are explored to obtain such VT difference while using the same type of transistor. Ultra-low power operation and low line sensitivity is achieved by biasing the SCM with a zero-VT (native) transistor, also leading to an area efficient design. To show its versatility, three versions of the proposed circuit were fabricated in a standard 0.13-μm CMOS process. Measurement performed over five samples showed an average temperature coefficient of 150-1500 ppm/°C. Minimum supply voltages of 0.12-0.4 V was observed while providing reference voltages around tens of mV. The proposed circuits consume 0.33-50 pW at room temperature and minimum supply voltage. The occupied area for any version is less than 0.0012 mm2.
- 14 September 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Circuits and Systems I: Regular Papers
- Vol. 65 (11) , 3790-3799
A 0.12–0.4 V, Versatile 3-Transistor CMOS Voltage Reference for Ultra-Low Power Systems
In this paper, we propose an ultra-low power compact 3-transistor voltage reference capable of operating at ultra-low supply voltages. The proposed circuit is based on the self-cascode MOSFET (SCM), which provides a reference voltage proportional to the threshold voltage (VT) difference of the two NMOS transistors that compose it. Reverse short-channel and narrow-width effects are explored to obtain such VT difference while using the same type of transistor. Ultra-low power operation and low line sensitivity is achieved by biasing the SCM with a zero-VT (native) transistor, also leading to an area efficient design. To show its versatility, three versions of the proposed circuit were fabricated in a standard 0.13-μm CMOS process. Measurement performed over five samples showed an average temperature coefficient of 150-1500 ppm/°C. Minimum supply voltages of 0.12-0.4 V was observed while providing reference voltages around tens of mV. The proposed circuits consume 0.33-50 pW at room temperature and minimum supply voltage. The occupied area for any version is less than 0.0012 mm2.
- 11 October 2017
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Circuits and Systems I: Regular Papers
- Vol. 64 (12) , 3036-3046
Picowatt, 0.45–0.6 V Self-Biased Subthreshold CMOS Voltage Reference
In this paper, a self-biased temperature-compensated CMOS voltage reference operating at picowatt-level power consumption is presented. The core of the proposed circuit is the self-cascode MOSFET (SCM) and two variants are explored: a self-biased SCM (SBSCM) and a self-biased NMOS (SBNMOS) voltage reference. Power consumption and silicon area are remarkably reduced by combining subthreshold operation with a self-biased scheme. Trimming techniques for both circuits are discussed aiming at the reduction of the process variations impact. The proposed circuits were fabricated in a standard 0.18-$\mu \text{m}$ CMOS process. Measurement results from 24 samples of the same batch show that both circuits herein proposed can operate at 0.45/0.6 V minimum supply voltage, consuming merely 55/184 pW at room temperature. Temperature coefficient (TC) around 104/495 ppm/°C across a temperature range from 0 to 120 °C was measured. Employment of a trimming scheme allows a reduction of the average TC to 72.4/11.6 ppm/°C for the same temperature range. Both variants of the proposed circuit achieve a line sensitivity of 0.15/0.11 %/V and a power supply rejection better than −44/−45 dB from 10 to 10 kHz. In addition, SBSCM and SBNMOS prototypes occupy a silicon area of 0.002 and 0.0017 mm2, respectively.- 11 October 2017
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Circuits and Systems I: Regular Papers
- Vol. 64 (12) , 3036-3046
Picowatt, 0.45–0.6 V Self-Biased Subthreshold CMOS Voltage Reference
In this paper, a self-biased temperature-compensated CMOS voltage reference operating at picowatt-level power consumption is presented. The core of the proposed circuit is the self-cascode MOSFET (SCM) and two variants are explored: a self-biased SCM (SBSCM) and a self-biased NMOS (SBNMOS) voltage reference. Power consumption and silicon area are remarkably reduced by combining subthreshold operation with a self-biased scheme. Trimming techniques for both circuits are discussed aiming at the reduction of the process variations impact. The proposed circuits were fabricated in a standard 0.18-$\mu \text{m}$ CMOS process. Measurement results from 24 samples of the same batch show that both circuits herein proposed can operate at 0.45/0.6 V minimum supply voltage, consuming merely 55/184 pW at room temperature. Temperature coefficient (TC) around 104/495 ppm/°C across a temperature range from 0 to 120 °C was measured. Employment of a trimming scheme allows a reduction of the average TC to 72.4/11.6 ppm/°C for the same temperature range. Both variants of the proposed circuit achieve a line sensitivity of 0.15/0.11 %/V and a power supply rejection better than −44/−45 dB from 10 to 10 kHz. In addition, SBSCM and SBNMOS prototypes occupy a silicon area of 0.002 and 0.0017 mm2, respectively.- 28 July 2016
- Published by Springer Nature in Analog Integrated Circuits and Signal Processing
- Vol. 89 (3) , 585-592
A CMOS low noise transconductance amplifier for 1–6 GHz bands
- 28 July 2016
- Published by Springer Nature in Analog Integrated Circuits and Signal Processing
- Vol. 89 (3) , 585-592
A CMOS low noise transconductance amplifier for 1–6 GHz bands
- 2 June 2016
- Published by Springer Nature in Analog Integrated Circuits and Signal Processing
- Vol. 89 (1) , 45-59
EMI resisting MOSFET-only voltage reference based on ZTC condition
- 2 June 2016
- Published by Springer Nature in Analog Integrated Circuits and Signal Processing
- Vol. 89 (1) , 45-59
EMI resisting MOSFET-only voltage reference based on ZTC condition
- 1 February 2016
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 71-74
A 90 dB PSRR, 4 dBm EMI resistant MOSFET-Only Voltage Reference
- 1 February 2016
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 71-74
A 90 dB PSRR, 4 dBm EMI resistant MOSFET-Only Voltage Reference
- Open Access
- 1 August 2015
- Published by Journal of Integrated Circuits and Systems in Journal of Integrated Circuits and Systems
- Vol. 10 (2) , 103-112
MOSFET ZTC Condition Analysis for a Self-biased Current Reference Design
In this paper a self-biased current reference based on Metal-Oxide-Semiconductor Field Effect Transistor (MOSFET) Zero Temperature Coefficient (ZTC) condition is proposed. It can be implemented in any Complementary Metal-Oxide-Semiconductor (CMOS) fabrication process and provides another alternative to design current references. In order to support the circuit design, ZTC condition is analyzed using a MOSFET model that is continuous from weak to strong inversion, showing that this condition always occurs from moderate to strong inversion in any CMOS process. The proposed topology was designed in a 180 nm process, operates with a supply voltage from 1.4V to 1.8 V and occupies around 0.010mm2 of silicon area. From circuit simulations our reference showed a temperature coefficient (TC) of 15 ppm/oC from -40 to +85oC, and a fabrication process sensitivity of σ/μ = 4.5% for the current reference, including average process and local mismatch variability analysis. The simulated power supply sensitivity is estimated around 1%/V.
- 1 August 2015
- Published by Journal of Integrated Circuits and Systems in Journal of Integrated Circuits and Systems
- Vol. 10 (2) , 103-112
Open AccessMOSFET ZTC Condition Analysis for a Self-biased Current Reference Design
In this paper a self-biased current reference based on Metal-Oxide-Semiconductor Field Effect Transistor (MOSFET) Zero Temperature Coefficient (ZTC) condition is proposed. It can be implemented in any Complementary Metal-Oxide-Semiconductor (CMOS) fabrication process and provides another alternative to design current references. In order to support the circuit design, ZTC condition is analyzed using a MOSFET model that is continuous from weak to strong inversion, showing that this condition always occurs from moderate to strong inversion in any CMOS process. The proposed topology was designed in a 180 nm process, operates with a supply voltage from 1.4V to 1.8 V and occupies around 0.010mm2 of silicon area. From circuit simulations our reference showed a temperature coefficient (TC) of 15 ppm/oC from -40 to +85oC, and a fabrication process sensitivity of σ/μ = 4.5% for the current reference, including average process and local mismatch variability analysis. The simulated power supply sensitivity is estimated around 1%/V.