VMVendula Maulerova

Vendula Maulerova

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Vendula Maulerova has a total of 26 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    First evaluation of a novel ionisation chamber for thermal neutron beam monitoring

    by Vendula Maulerová, Kalliopi Kanaki, Martin Klein, Christian J. Schmidt, Peter M. Kadletz, Alessio Laloni, Richard J. Hall-Wilton

    The European Spallation Source ERIC (ESS), currently under construction in Lund, Sweden is a facility established to deliver the highest integrated neutron flux originating from a pulsed source with the aim of supporting an initial fifteen neutron instruments for cutting edge science experiments. This in turn requires reliable monitoring at complex neutron beam lines: in particular, linearity, timing capability, adaptability of the design for various flux ranges (dynamic range) and sensitivity to neutrons within the range of 0.6-10Å are expected from the neutron beam monitors to be installed at the ESS beam lines. Additionally, operational stability and low attenuation are also desirable characteristics for such neutron beam monitoring. A prototype neutron beam monitor based on the ionisation chamber principle and a boron converter, designed by CDT CASCADE Detector Technologies GmbH and ESS, has been investigated at the BER-II research reactor of Helmholtz Zentrum Berlin (HZB). The effort to design and investigate a thermal neutron ionisation beam monitor was initiated by adapting the concept of ionisation chambers previously known elsewhere. So far all the characterised neutron beam monitors discriminate neutron hits on a discrete event basis (pulse mode), whereas the beam monitor prototype introduced in this paper estimates the total flux as a function of current (current mode). While most other neutron beam monitoring devices and detectors rely upon a signal amplifying gain stage, the ionisation chamber operates without any gain and is consequently robust against typical detector ageing effects that compromise the sensitivity over time. The initial tests were performed at the ESS V20 test beam line under realistic conditions resembling those of the future pulses of ESS. The linearity is demonstrated for 3Å pulses in the flux range of 2-3 × 105 n/s/cm2 and for white pulses (0.6-10Å) in the range of 1-5 × 106 n/s/cm2. The timing behaviour resembles the data previously recorded at the V20 beam lines. This novel implementation of a neutron sensitive ionisation chamber shows great promise for beam monitoring and diagnostics at ESS. As the ionisation beam monitor itself is an entirely passive device, it is adequately robust to be employed in areas of high irradiation where no regular servicing or maintenance can be provided.


  • Open Access

    Simulation of the response of the Solid State Neutron Detector for the European Spallation Source

    by L. Boyd, E. Rofors, J.R.M. Annand, K.G. Fissum, R. Hall-Wilton, R. Al Jebali, K. Kanaki, K. Livingston, V. Maulerova, N. Mauritzson, et al.


  • Open Access

    Vanadium-based neutron beam monitor

    by V. Maulerova, K. Kanaki, P. M. Kadletz, R. Woracek, T. Wilpert, K. Fissum, A. Laloni, N. Mauritzson, F. Issa, R. Hall-Wilton

    A prototype quasiparasitic thermal neutron beam monitor based on isotropic neutron scattering from a thin natural vanadium foil and standard He3 proportional counters is conceptualized, designed, simulated, calibrated, and commissioned. The European Spallation Source designed to deliver the highest integrated neutron flux originating from a pulsed source is currently under construction in Lund, Sweden. The effort to investigate a vanadium-based neutron beam monitor was triggered by a list of requirements for beam monitors permanently placed in the ESS neutron beams in order to provide reliable monitoring at complex beam lines: low attenuation, linear response over a wide range of neutron fluxes, near to constant efficiency for neutron wavelengths in a range of 0.6–10 Å, calibration stability and the possibility to place the system in vacuum are all desirable characteristics. The scattering-based prototype, employing a natural vanadium foil and standard He3 proportional counters, was investigated at the V17 and V20 neutron beam lines of the Helmholtz-Zentrum in Berlin, Germany, in several different geometrical configurations of the He3 proportional counters around the foil. Response linearity is successfully demonstrated for foil thicknesses ranging from 0.04 mm to 3.15 mm. Attenuation lower than 1% for thermal neutrons is demonstrated for the 0.04 mm and 0.125 mm foils. The geometries used for the experiment were simulated allowing for absolute flux calibration and establishing the possible range of efficiencies for various designs of the prototype. The operational flux limits for the beam monitor prototype were established as a dependency of the background radiation and prototype geometry. The herein demonstrated prototype monitors can be employed for neutron intensities ranging from 103–1010  n/s.


  • Parallel-Coupled Quantum Dots in InAs Nanowires

    by Malin Nilsson, I-Ju Chen, Sebastian Lehmann, Vendula Maulerova, Kimberly A. Dick, Claes Thelander

    We use crystal-phase tuning during epitaxial growth of InAs nanowires to create quantum dots with very strong confinement. A set of gate electrodes are used to reproducibly split the quantum dots into even smaller pairs for which we can control the populations down to the last electron. The double quantum dots, which are parallel-coupled to source and drain, show clear and stable odd–even level pairing due to spin degeneracy and the strong confinement. The combination of hard-wall barriers to source and drain, shallow interdot tunnel barriers, and very high single-particle excitation energies allow an order of magnitude tuning of the strength for the first intramolecular bond. We show examples for nanowires with different facet orientations, and suggest possible mechanisms behind the reproducible double-dot formation.