HKHasan Karaca

Hasan Karaca

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Hasan Karaca has a total of 6 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • 3-D TCAD Methodology for Simulating Double-Hysteresis Filamentary I–V Behavior and Holding Current in ESD Protection SCRs

    by Hasan Karaca, Steffen Holland, Hans-Martin Ritter, Vasantha Kumar, Guido Notermans, Dionyz Pogany

    Current filament (CF)-related double-hysteresis ${I}$ – ${V}$ behavior and holding current, ${I} _{\text {HOLD}}$ , are analyzed using experiments and 3-D technology computer-aided design (TCAD) simulation in silicon-controlled rectifiers (SCR) for system-level electrostatic discharge (ESD) protection. Our 3-D TCAD methodology uses up and down quasi-dc current sweeps to reveal a memory effect in the current density distribution along the device width. ${I} _{\text {HOLD}}$ is related to the smallest possible CF where the self-sustaining SCR action takes place during down current sweep. ${I} _{\text {HOLD}}$ exhibits a nontrivial dependence on device width, depending on whether a CF is created or not. Analyzing devices of different layouts shows that ${I} _{\text {HOLD}}$ values determined from experiments and 3-D TCAD are almost layout-independent and substantially lower than those evaluated from 2-D TCAD. ${I} _{\text {HOLD}}$ calculated by 3-D TCAD in edge-terminated devices is higher than that in 3-D structures obtained from simple width-extended 2-D doping profiles. The use of latter devices, thus, simplifies the 3-D TCAD ${I}$ – ${V}$ analysis and provides a safe margin for ${I} _{\text {HOLD}}$ prediction. The work is relevant for designing the latch-up immunity of ESD protection devices, and it also shows that conventional 2-D TCAD can provide unwanted overestimation of ${I} _{\text {HOLD}}$ .


  • Simultaneous and Sequential Triggering in Multi-Finger Floating-Base SCRs Depending on TLP Pulse Rise Time

    by Hasan Karaca, Clement Fleury, Steffen Holland, Vasantha Kumar, Hans-Martin Ritter, Guido Notermans, Dionyz Pogany

    Multi-finger floating-base silicon controlled rectifiers (SCRs) of discrete technologies are investigated by transmission line pulses (TLP) with short (300ps) and long (10ns) pulse rise times (RT). Transient interferometric mapping (TIM) is applied to study the finger triggering dynamics. The measurements are correlated with TCAD simulation. It is found that for short RT the fingers trigger simultaneously which is due to the positive influence of a voltage overshoot related to delayed conductivity modulation. For long RT the fingers trigger sequentially which is accompanied by the voltage drops near the holding voltage. The time delay between the triggering of neighboring fingers is in the 3-150ns range and depends on the actual current density in fingers. The sequential finger triggering is due to lateral carrier diffusion-limited processes and the coupling via substrate currents.