Maíra Laskoski
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Maíra Laskoski has a total of 9 co-authors. Here are the top co-authors by number of shared publications:
- Guilherme Luiz Parize
Universidade Federal do Paraná, Brazil
3 shared publications - Samir Paulo Jasper
Universidade Federal do Paraná (UFPR), Brasil
3 shared publications - Lauro Strapasson Neto
Universidade Federal do Paraná, Brazil
2 shared publications - Leonardo Leonidas Kmiecik
Universidade Federal do Paraná, Brazil
2 shared publications Camilla Weber Langhinotti
UFPR
1 shared publication- Daniel Savi
Universidade Federal do Paraná (UFPR), Brazil
1 shared publication
Latest Publications
- Open Access
- 1 January 2023
- Published by FapUNIFESP (SciELO) in Ciência Rural
- Vol. 53 (3)
Agricultural tractor with different mass distributions between axles
An adjustment of the agricultural tractor is necessary to achieve energy efficiency, which can be done through the correct distribution of mass between the axles for each operating surface. This research evaluated different distributions of mass between axles in a 93 kW tractor equipped with auxiliary front-wheel drive, on two soil surfaces. The experiment was carried out in strip design, with a double factorial scheme (2 x 3), with two soil surfaces (mobilized and firm) and three mass distributions between axes (35/65%, 40/60% and 45/55%), with five repetitions, totaling 30 parcels. The slippage parameters of the front and rear wheelset, engine rotation, hourly and specific fuel consumption, force, power and yield on the drawbar, displacement speed, engine thermal efficiency, traction coefficient, rolling resistance, and yield in traction. On firm soil, the energy performance of the tractor was superior in relation to the mobilized one, which allowed greater tractor and drawbar performance with lower specific fuel consumption. The use of a 35/65% between-axle mass distribution provided maximum traction for the mechanized set, resulting from the reduction in energy expenditure generated by skating and; consequently, the maximum use of the energy made available by the mechanized set. However, the maximum conversion of energy contained in the working fuel is obtained with the 45/55% setting.
- 1 January 2023
- Published by FapUNIFESP (SciELO) in Ciência Rural
- Vol. 53 (3)
Open AccessAgricultural tractor with different mass distributions between axles
An adjustment of the agricultural tractor is necessary to achieve energy efficiency, which can be done through the correct distribution of mass between the axles for each operating surface. This research evaluated different distributions of mass between axles in a 93 kW tractor equipped with auxiliary front-wheel drive, on two soil surfaces. The experiment was carried out in strip design, with a double factorial scheme (2 x 3), with two soil surfaces (mobilized and firm) and three mass distributions between axes (35/65%, 40/60% and 45/55%), with five repetitions, totaling 30 parcels. The slippage parameters of the front and rear wheelset, engine rotation, hourly and specific fuel consumption, force, power and yield on the drawbar, displacement speed, engine thermal efficiency, traction coefficient, rolling resistance, and yield in traction. On firm soil, the energy performance of the tractor was superior in relation to the mobilized one, which allowed greater tractor and drawbar performance with lower specific fuel consumption. The use of a 35/65% between-axle mass distribution provided maximum traction for the mechanized set, resulting from the reduction in energy expenditure generated by skating and; consequently, the maximum use of the energy made available by the mechanized set. However, the maximum conversion of energy contained in the working fuel is obtained with the 45/55% setting.
- Open Access
- 1 April 2021
- Published by FapUNIFESP (SciELO) in Revista Brasileira de Engenharia Agrícola E Ambiental
- Vol. 25 (4) , 277-281
Agricultural tractor traction efficiency by changing the mass distribution between axles and speed
The traction efficiency of the agricultural tractor can be maximized by adjusting the total mass and its distribution between the axles. The experiment’s objective was to determine the configuration of mass distribution between axles and the displacement speed that provides greater traction efficiency in the harrowing operation. A randomized block design in a 2 × 3 factorial scheme with five replications was used. The first factor was two mass distributions between axles, and the second factor was three gears. The collected data were submitted to analysis of variance and the Tukey test. The condition that maximizes the tractor’s performance corresponds to 39% of the total mass on the front axle and 61% on the rear axle, with a gear that provides speed close to 10 km h-1.
- 1 April 2021
- Published by FapUNIFESP (SciELO) in Revista Brasileira de Engenharia Agrícola E Ambiental
- Vol. 25 (4) , 277-281
Open AccessAgricultural tractor traction efficiency by changing the mass distribution between axles and speed
The traction efficiency of the agricultural tractor can be maximized by adjusting the total mass and its distribution between the axles. The experiment’s objective was to determine the configuration of mass distribution between axles and the displacement speed that provides greater traction efficiency in the harrowing operation. A randomized block design in a 2 × 3 factorial scheme with five replications was used. The first factor was two mass distributions between axles, and the second factor was three gears. The collected data were submitted to analysis of variance and the Tukey test. The condition that maximizes the tractor’s performance corresponds to 39% of the total mass on the front axle and 61% on the rear axle, with a gear that provides speed close to 10 km h-1.
- Open Access
- 6 March 2017
- Published by Universidade Federal do Parana in Scientia Agraria
- Vol. 17 (3) , 55-60
DESEMPENHO DO TRATOR DE 157KW NA CONDIÇÃO MANUAL E AUTOMÁTICO DE GERENCIAMENTO DE MARCHAS
O sistema de gerenciamento automático de marchas permite ao trator, na rotação de trabalho estabelecida no motor, extrair o máximo de desempenho de tração do trator. Neste trabalho, os benefícios de gerenciamento automático de marchas foram comprovados através da comparação da velocidade, patinagem, consumo horário de combustível, rendimento e potência na barra de tração, força e consumo específico durante deslocamento do trator nas condições manual e automática de gerenciamento de marcha. O experimento foi conduzido em delineamento em faixas, com dois tratamentos (marchas selecionadas manualmente e automaticamente) e cinco repetições. Os parâmetros foram determinados pelo método de comboio composto por dois tratores conduzidos em pavimento de concreto à velocidade de 8,0 km h-1 e o segundo trator simulando carga de 40 kN na barra de tração. O gerenciamento automático e manual das marchas não resultou em diferença significativa na força e patinagem. Contudo, o gerenciamento automático de marchas permitiu que o trator atingisse maior velocidade com menor consumo específico e horário de combustível, com respectivo aumento na potência e rendimento na barra de tração. Palavras–chave: Tratores agrícolas; caixa de câmbio; eficiência tratativa.
- 6 March 2017
- Published by Universidade Federal do Parana in Scientia Agraria
- Vol. 17 (3) , 55-60
Open AccessDESEMPENHO DO TRATOR DE 157KW NA CONDIÇÃO MANUAL E AUTOMÁTICO DE GERENCIAMENTO DE MARCHAS
O sistema de gerenciamento automático de marchas permite ao trator, na rotação de trabalho estabelecida no motor, extrair o máximo de desempenho de tração do trator. Neste trabalho, os benefícios de gerenciamento automático de marchas foram comprovados através da comparação da velocidade, patinagem, consumo horário de combustível, rendimento e potência na barra de tração, força e consumo específico durante deslocamento do trator nas condições manual e automática de gerenciamento de marcha. O experimento foi conduzido em delineamento em faixas, com dois tratamentos (marchas selecionadas manualmente e automaticamente) e cinco repetições. Os parâmetros foram determinados pelo método de comboio composto por dois tratores conduzidos em pavimento de concreto à velocidade de 8,0 km h-1 e o segundo trator simulando carga de 40 kN na barra de tração. O gerenciamento automático e manual das marchas não resultou em diferença significativa na força e patinagem. Contudo, o gerenciamento automático de marchas permitiu que o trator atingisse maior velocidade com menor consumo específico e horário de combustível, com respectivo aumento na potência e rendimento na barra de tração. Palavras–chave: Tratores agrícolas; caixa de câmbio; eficiência tratativa.