Takuma Sato
Research Subjects
Takuma Sato has a total of 18 co-authors. Here are the top co-authors by number of shared publications:
- Borislav Petrović
Julius-Maximilians-Universität Würzburg, Physikalisches Institut, Lehrstuhl für Technische Physik 1 , Am Hubland, 97074 Würzburg, Germany
3 shared publications - Fabian Hartmann
Julius-Maximilians-Universität Würzburg
3 shared publications - Robert Weih
Nanoplus Advanced Photonics Gerbrunn GmbH 2 , Oberer Kirschberg 4, 97218 Gerbrunn, Germany
3 shared publications - Andreas Bader
Julius-Maximilians-Universität Würzburg, Physikalisches Institut, Lehrstuhl für Technische Physik 1 , Am Hubland, 97074 Würzburg, Germany
2 shared publications - Gerrit E. W. Bauer
Tohoku University
2 shared publications - Josephine Nauschütz
Nanoplus Nanosystems and Technologies GmbH 2 , Gerbrunn
2 shared publications
Latest Publications
- Open Access
- 9 March 2026
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 139 (10)
Impact of carrier injector design on the threshold of interband cascade lasers
We theoretically investigate how the injector region design of interband cascade lasers (ICLs) impacts the threshold carrier and current densities. The model combines a polarization-sensitive 8-band k⋅p calculation, electrostatics, and a microscopic calculation of Auger recombination rates. The inelastic carrier–carrier scattering is included at the lowest order using quasi-equilibrium Green’s functions. Our approach captures the combined effects of charge-carrier redistribution, parasitic absorption, and bias voltage on the Auger recombination rate. We show that heavily doping the electron injector suppresses the dominant multi-hole Auger recombination by reducing the hole population of the recombination quantum wells. This agrees with the experimental observation that the heavy doping reduces threshold currents. Unlike the measurements, however, they do not increase at high doping concentrations in our model, which does not include scattering-mediated carrier escape and/or light absorption. Furthermore, by introducing indium to the conventional GaSb hole injector wells, we explain the rule of thumb from experiments that raising the hole injector levels does not outperform the doping strategy. Our model provides physical insights for optimizing ICL carrier injectors.
- 9 March 2026
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 139 (10)
Open AccessImpact of carrier injector design on the threshold of interband cascade lasers
We theoretically investigate how the injector region design of interband cascade lasers (ICLs) impacts the threshold carrier and current densities. The model combines a polarization-sensitive 8-band k⋅p calculation, electrostatics, and a microscopic calculation of Auger recombination rates. The inelastic carrier–carrier scattering is included at the lowest order using quasi-equilibrium Green’s functions. Our approach captures the combined effects of charge-carrier redistribution, parasitic absorption, and bias voltage on the Auger recombination rate. We show that heavily doping the electron injector suppresses the dominant multi-hole Auger recombination by reducing the hole population of the recombination quantum wells. This agrees with the experimental observation that the heavy doping reduces threshold currents. Unlike the measurements, however, they do not increase at high doping concentrations in our model, which does not include scattering-mediated carrier escape and/or light absorption. Furthermore, by introducing indium to the conventional GaSb hole injector wells, we explain the rule of thumb from experiments that raising the hole injector levels does not outperform the doping strategy. Our model provides physical insights for optimizing ICL carrier injectors.
- 11 June 2024
- Published by American Vacuum Society in Journal of Vacuum Science & Technology B
- Vol. 42 (4)
5.0 μm emitting interband cascade lasers with superlattice and bulk AlGaAsSb claddings
We present a comparison between interband cascade lasers (ICLs) with a six-stage active region emitting at 5 μm with AlSb/InAs superlattice claddings and with bulk Al0.85Ga0.15As0.07Sb0.93 claddings. Utilizing bulk AlGaAsSb claddings with their lower refractive index compared to the more commonly used AlSb/InAs superlattice claddings, the mode-confinement in the active region increases by 14.4% resulting in an improvement of the lasing threshold current density. For broad area laser and under pulsed excitation, the ICL with AlGaAsSb claddings shows a lower threshold current density of Jth=396A/cm2 compared to Jth=521A/cm2 of the ICL with superlattice claddings. Additionally, a higher characteristic temperature was obtained for the ICL with bulk claddings. Emission in pulsed operation is observed up to 65 °C.
- 11 June 2024
- Published by American Vacuum Society in Journal of Vacuum Science & Technology B
- Vol. 42 (4)
5.0 μm emitting interband cascade lasers with superlattice and bulk AlGaAsSb claddings
We present a comparison between interband cascade lasers (ICLs) with a six-stage active region emitting at 5 μm with AlSb/InAs superlattice claddings and with bulk Al0.85Ga0.15As0.07Sb0.93 claddings. Utilizing bulk AlGaAsSb claddings with their lower refractive index compared to the more commonly used AlSb/InAs superlattice claddings, the mode-confinement in the active region increases by 14.4% resulting in an improvement of the lasing threshold current density. For broad area laser and under pulsed excitation, the ICL with AlGaAsSb claddings shows a lower threshold current density of Jth=396A/cm2 compared to Jth=521A/cm2 of the ICL with superlattice claddings. Additionally, a higher characteristic temperature was obtained for the ICL with bulk claddings. Emission in pulsed operation is observed up to 65 °C.
- 10 June 2024
- Published by AIP Publishing in Applied Physics Letters
- Vol. 124 (24)
GaSb-based interband cascade laser with hybrid superlattice plasmon-enhanced claddings
We present an interband cascade laser (ICL) emitting at 5.2 µm consisting of an 8-stage active region and a hybrid cladding composed of outer plasmon-enhanced InAs0.915Sb0.085 and inner InAs/AlSb superlattice claddings. The hybrid cladding architecture shows an increase in mode confinement in the active region by 11.2% according to the simulation. This is a consequence of a significantly lower refractive index of plasmon-enhanced claddings. The threshold current density is 242 A/cm2 in pulsed operation at room temperature. This is the lowest value reported to date for ICLs emitting at wavelengths longer than 5 µm. We also report close to record value threshold power density of 840 W/cm2 for ICLs at such wavelengths.
- 10 June 2024
- Published by AIP Publishing in Applied Physics Letters
- Vol. 124 (24)
GaSb-based interband cascade laser with hybrid superlattice plasmon-enhanced claddings
We present an interband cascade laser (ICL) emitting at 5.2 µm consisting of an 8-stage active region and a hybrid cladding composed of outer plasmon-enhanced InAs0.915Sb0.085 and inner InAs/AlSb superlattice claddings. The hybrid cladding architecture shows an increase in mode confinement in the active region by 11.2% according to the simulation. This is a consequence of a significantly lower refractive index of plasmon-enhanced claddings. The threshold current density is 242 A/cm2 in pulsed operation at room temperature. This is the lowest value reported to date for ICLs emitting at wavelengths longer than 5 µm. We also report close to record value threshold power density of 840 W/cm2 for ICLs at such wavelengths.
- 11 July 2022
- Published by American Physical Society (APS) in Physical Review B
- Vol. 106 (1) , 014407
Magnetization dynamics affected by phonon pumping
“Pumping” of phonons by a dynamic magnetization promises to extend the range and functionality of magnonic devices. We explore the impact of phonon pumping on room-temperature ferromagnetic resonance (FMR) spectra of bilayers of thin yttrium iron garnet films on thick gadolinium gallium garnet substrates over a wide frequency range. At low frequencies the Kittel mode hybridizes with standing ultrasound waves across the layer stack that acts as a bulk acoustic resonator to form magnon polarons with rapid oscillations in the magnetic susceptibility, as reported before. At higher frequencies, the individual phonon resonances overlap due to their increasing acoustic attenuation, leading to an additional slowly oscillating phonon pumping contribution to the FMR line shape. The broadband frequency dependence of the magnetoelastic coupling strength follows the predictions from phonon pumping theory in the thick substrate limit. In addition, we find substantial magnon-phonon coupling of a perpendicular standing spin wave mode. This evidences the importance of the mode overlap between the acoustic and magnetic modes and provides a route towards engineering the magnetoelastic mode coupling.
- 11 July 2022
- Published by American Physical Society (APS) in Physical Review B
- Vol. 106 (1) , 014407
Magnetization dynamics affected by phonon pumping
“Pumping” of phonons by a dynamic magnetization promises to extend the range and functionality of magnonic devices. We explore the impact of phonon pumping on room-temperature ferromagnetic resonance (FMR) spectra of bilayers of thin yttrium iron garnet films on thick gadolinium gallium garnet substrates over a wide frequency range. At low frequencies the Kittel mode hybridizes with standing ultrasound waves across the layer stack that acts as a bulk acoustic resonator to form magnon polarons with rapid oscillations in the magnetic susceptibility, as reported before. At higher frequencies, the individual phonon resonances overlap due to their increasing acoustic attenuation, leading to an additional slowly oscillating phonon pumping contribution to the FMR line shape. The broadband frequency dependence of the magnetoelastic coupling strength follows the predictions from phonon pumping theory in the thick substrate limit. In addition, we find substantial magnon-phonon coupling of a perpendicular standing spin wave mode. This evidences the importance of the mode overlap between the acoustic and magnetic modes and provides a route towards engineering the magnetoelastic mode coupling.
- 6 July 2021
- Published by American Physical Society (APS) in Physical Review B
- Vol. 104 (1) , 014403
Dynamic magnetoelastic boundary conditions and the pumping of phonons
We derive boundary conditions at the interfaces of magnetoelastic heterostructures under ferromagnetic resonance for arbitrary magnetization directions and interface shapes. We apply our formalism to bilayers and magnetic grains embedded in a nonmagnetic thin film, revealing a nontrivial magnetization angle dependence of acoustic phonon pumping.- 6 July 2021
- Published by American Physical Society (APS) in Physical Review B
- Vol. 104 (1) , 014403
Dynamic magnetoelastic boundary conditions and the pumping of phonons
We derive boundary conditions at the interfaces of magnetoelastic heterostructures under ferromagnetic resonance for arbitrary magnetization directions and interface shapes. We apply our formalism to bilayers and magnetic grains embedded in a nonmagnetic thin film, revealing a nontrivial magnetization angle dependence of acoustic phonon pumping.