Jiaqi Lu
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Jiaqi Lu has a total of 17 co-authors. Here are the top co-authors by number of shared publications:
- Fang Liu
Southwest Jiaotong University
2 shared publications - Guoping Li
Laboratory of Allergy and Precision Medicine, Chengdu Institute of Respiratory Health, Affiliated Hospital of Southwest Jiaotong University, The Third People’s Hospital of Chengdu, Chengdu 610031, Sichuan, China
2 shared publications - Kun Tang
School of Information Science and Technology, Southwest Jiaotong University, Chengdu, China
2 shared publications - Xiang Yu
School of Information Science and Technology, Southwest Jiaotong University, Chengdu, China
2 shared publications - Xiangdong Chen
Southwest Jiaotong University
2 shared publications - Xing Ding
School of Information Science and Technology, Southwest Jiaotong University, Chengdu, China
2 shared publications
Latest Publications
- Open Access
- 17 June 2024
- Published by Wiley in Advanced Science
- Vol. 11 (31) , e2401940
Droplet Micro‐Sensor and Detection of Respiratory Droplet Transmission
Droplet transmission is the primary infection route for respiratory diseases like COVID‐19 and influenza, but small and low‐cost wearable droplet detection devices are a significant challenge. Herein, a respiratory droplet micro‐sensor based on graphene oxide quantum dots (GOQDs) assembled onto SiO2 microspheres by the nebulized natural deposition is presented. Benefiting from the energy dissipation of the microsphere to droplets, the sensor can detect droplets as far as 2 m from coughing. With this sensor, droplet signal variations caused by some factors like distance, speech, angles, and wind directions are explored, and the effectiveness of different protective measures in preventing droplet transmission is evaluated. This droplet detection technology is expected to be utilized for the development of personal detection and protection devices against infectious respiratory diseases.
- 17 June 2024
- Published by Wiley in Advanced Science
- Vol. 11 (31) , e2401940
Open AccessDroplet Micro‐Sensor and Detection of Respiratory Droplet Transmission
Droplet transmission is the primary infection route for respiratory diseases like COVID‐19 and influenza, but small and low‐cost wearable droplet detection devices are a significant challenge. Herein, a respiratory droplet micro‐sensor based on graphene oxide quantum dots (GOQDs) assembled onto SiO2 microspheres by the nebulized natural deposition is presented. Benefiting from the energy dissipation of the microsphere to droplets, the sensor can detect droplets as far as 2 m from coughing. With this sensor, droplet signal variations caused by some factors like distance, speech, angles, and wind directions are explored, and the effectiveness of different protective measures in preventing droplet transmission is evaluated. This droplet detection technology is expected to be utilized for the development of personal detection and protection devices against infectious respiratory diseases.
- 25 April 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Sensors Journal
- Vol. 23 (11) , 11547-11553
Highly Sensitive QCM Humidity Sensor Based on Fullerenol-Assisted Dispersion of Nafion/MWCNTs Composites
Water seepage of building walls is a common problem in our lives. However, the lack of early seepage detection methods often makes the problem worse. To develop effective early wall seepage detection methods, an ultra-sensitive quartz crystal microbalance (QCM) humidity sensor based on fullerenol (C 60 -OH)-assisted dispersion of Nafion/multi-walled carbon nanotubes (MWCNTs) composites is proposed. The prepared sensor shows almost 7 times higher frequency shift than pure Nafion-based sensor, which reaches -10814 Hz. This is mainly attributed to the uniform dispersion of MWCNTs in the Nafion with the assistance of C 60 -OH to form a reticular structure that generates more voids, which greatly improves the diffusion ability of water molecules in the composite materials and thus further enhances humidity sensing properties of the sensor. The high-performance QCM humidity sensor is expected to be used for early detection of water seepage in building walls by monitoring air humidity changes near the wall surface.
- 25 April 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Sensors Journal
- Vol. 23 (11) , 11547-11553
Highly Sensitive QCM Humidity Sensor Based on Fullerenol-Assisted Dispersion of Nafion/MWCNTs Composites
Water seepage of building walls is a common problem in our lives. However, the lack of early seepage detection methods often makes the problem worse. To develop effective early wall seepage detection methods, an ultra-sensitive quartz crystal microbalance (QCM) humidity sensor based on fullerenol (C 60 -OH)-assisted dispersion of Nafion/multi-walled carbon nanotubes (MWCNTs) composites is proposed. The prepared sensor shows almost 7 times higher frequency shift than pure Nafion-based sensor, which reaches -10814 Hz. This is mainly attributed to the uniform dispersion of MWCNTs in the Nafion with the assistance of C 60 -OH to form a reticular structure that generates more voids, which greatly improves the diffusion ability of water molecules in the composite materials and thus further enhances humidity sensing properties of the sensor. The high-performance QCM humidity sensor is expected to be used for early detection of water seepage in building walls by monitoring air humidity changes near the wall surface.