Sujit Kumbhar
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Sujit Kumbhar has a total of 14 co-authors. Here are the top co-authors by number of shared publications:
Sanjay Khot
3 shared publications- Avesahemad S. N. Husainy
Sharad Institute of Technology College of Engineering
2 shared publications - Sanjay Khot
Sharad Institute of Technology, College of Engineering, Ichalkaranji, India
2 shared publications - Vishal V. Patil
Sharad Institute of Technology College of Engineering
2 shared publications - Anirban Sur
Department of Mechanical Engineering Symbiosis Institute of Technology Pune, Symbiosis International (Deemed University) Pune India
1 shared publication - Avadhut Jadhav
Bharati Vidyapeeths College of Engineering
1 shared publication
Latest Publications
- 1 May 2026
- Published by IOP Publishing in Engineering Research Express
- Vol. 8 (10) , 105505
Performance and emission analysis of spark ignition engine powered by premium gasoline-ethanol blends with partial addition of amyl alcohol, iso-butanol and hydrogen
The depletion of fossil fuels is one of the major challenges in front of all countries. Many countries already blended ethanol up to 20% in gasoline. In the current experimental investigations, the performance and emission characteristics of spark ignition engine is analyzed fueled with partial addition amyl alcohol, isobutanol and hydrogen enrichment as compared to premium gasoline (PG). The PG-ethanol blends were prepared with partial addition of amyl alcohol, isobutanol (10% by vol.). The engine testing was carried out at constant engine speed (2500 rpm) and hydrogen enrichment. It was observed that there was improvement in BTE by 2.7% and 1.7% with partial addition of isobutonol and amyl alcohol respectively as compared to PG. The BTE of PG10H 2 (33.4%) were found to maximum among all tested fuel blends and was 3.6% greater than PG. When compared to PG, the inclusion of E and AA raises peak cylinder pressure and slightly advances the pressure rise, indicating enhanced combustion intensity and faster heat release. It was observed that PG emits the most CO at about 3.3 g kWh −1 , but blending with ethanol gradually reduces CO to around 3.2 g kWh −1 , 2.85 g kWh −1 , and 2.65 g/. There was reduction in CO emission by 3%, 13.6% and 19.6% with addition 20%, 40% and 60% of ethanol content as compared to PG. HC reduces to around 0.088 g kWh −1 (12% reduction) for PG20E, 0.075 g kWh −1 (25% reduction) for PG40E, and 0.060 g kWh −1 (40% reduction) for PG60E when ethanol is added. Blending with ethanol reduces NO x levels to around 8.6 g kWh −1 (≈3.4% reduction) for PG20E, 8.4 g kWh −1 (≈5.6%) for PG40E, and 8.2 g kWh −1 (≈7.9%) for PG60E. Amyl alcohol blends result in a significant drop, with PG10AA showing around 6.4 g kWh −1 (≈28% reduction), followed by 6.1 g kWh −1 (≈31% reduction), 5.9 g kWh −1 (≈34%), and 5.7 g kWh −1 (≈36%) for PG20E10AA, PG40E10AA, and PG60E10AA, respectively. Based on current investigations, PG20E blends showed comparative results to PG.
- 1 May 2026
- Published by IOP Publishing in Engineering Research Express
- Vol. 8 (10) , 105505
Performance and emission analysis of spark ignition engine powered by premium gasoline-ethanol blends with partial addition of amyl alcohol, iso-butanol and hydrogen
The depletion of fossil fuels is one of the major challenges in front of all countries. Many countries already blended ethanol up to 20% in gasoline. In the current experimental investigations, the performance and emission characteristics of spark ignition engine is analyzed fueled with partial addition amyl alcohol, isobutanol and hydrogen enrichment as compared to premium gasoline (PG). The PG-ethanol blends were prepared with partial addition of amyl alcohol, isobutanol (10% by vol.). The engine testing was carried out at constant engine speed (2500 rpm) and hydrogen enrichment. It was observed that there was improvement in BTE by 2.7% and 1.7% with partial addition of isobutonol and amyl alcohol respectively as compared to PG. The BTE of PG10H 2 (33.4%) were found to maximum among all tested fuel blends and was 3.6% greater than PG. When compared to PG, the inclusion of E and AA raises peak cylinder pressure and slightly advances the pressure rise, indicating enhanced combustion intensity and faster heat release. It was observed that PG emits the most CO at about 3.3 g kWh −1 , but blending with ethanol gradually reduces CO to around 3.2 g kWh −1 , 2.85 g kWh −1 , and 2.65 g/. There was reduction in CO emission by 3%, 13.6% and 19.6% with addition 20%, 40% and 60% of ethanol content as compared to PG. HC reduces to around 0.088 g kWh −1 (12% reduction) for PG20E, 0.075 g kWh −1 (25% reduction) for PG40E, and 0.060 g kWh −1 (40% reduction) for PG60E when ethanol is added. Blending with ethanol reduces NO x levels to around 8.6 g kWh −1 (≈3.4% reduction) for PG20E, 8.4 g kWh −1 (≈5.6%) for PG40E, and 8.2 g kWh −1 (≈7.9%) for PG60E. Amyl alcohol blends result in a significant drop, with PG10AA showing around 6.4 g kWh −1 (≈28% reduction), followed by 6.1 g kWh −1 (≈31% reduction), 5.9 g kWh −1 (≈34%), and 5.7 g kWh −1 (≈36%) for PG20E10AA, PG40E10AA, and PG60E10AA, respectively. Based on current investigations, PG20E blends showed comparative results to PG.
- Open Access
- 1 January 2025
- Published by Kare Publishing in Sigma Journal of Engineering and Natural Sciences
- Vol. 43 (2) , 369-382
Thermal and emission analysis of spark ignition S.I engine using premium gasoline-ethanol-paraffin blends with different operating conditions
The release of greenhouse gases and climate change are mostly caused by internal combustion engine emissions from combustion fossil fuels, especially those from gasoline engines. Ethanol can be been recognized as an alternative fuel to gasoline that may also help to reduce pollution. In this paper, the various ethanol-premium gasoline blends with partial additions of paraffin such as n-pentane, hexane, etc. were evaluated for engine performance, combustion, and emission characteristics. CO emissions are reduced by 12 and 15% respectively when hexane and pentane are blended with premium gasoline and ethanol blends. PG40E10P fuel blend had the lowest emissions amongst all fuel blend used in spark ignition engine. Hydrocarbons have been seen to diminish with the addition of hexane and pentane. Partial addition of paraffin assisted complete combustion of fuel therby reducing hydrocarbon emissions by 25%. PG60E10P fuel blend found to have least HC emission amongst all fuel blends. In addition, the cylinder pressure dropped when ethanol was added. The maximum braking thermal efficiency was determined to be PG10P as compared to PG . Paraffin blends helped in complete combustion of fuel and hence BTE improved slightly by 7% as compared with PG. A partial addition of paraffin to gasoline was shown to reduce CO emissions by 10% as compared with PG. The nitrogen oxides (NOx) was found to decrease by 25% for PG40EP as compared to PG.
- 1 January 2025
- Published by Kare Publishing in Sigma Journal of Engineering and Natural Sciences
- Vol. 43 (2) , 369-382
Open AccessThermal and emission analysis of spark ignition S.I engine using premium gasoline-ethanol-paraffin blends with different operating conditions
The release of greenhouse gases and climate change are mostly caused by internal combustion engine emissions from combustion fossil fuels, especially those from gasoline engines. Ethanol can be been recognized as an alternative fuel to gasoline that may also help to reduce pollution. In this paper, the various ethanol-premium gasoline blends with partial additions of paraffin such as n-pentane, hexane, etc. were evaluated for engine performance, combustion, and emission characteristics. CO emissions are reduced by 12 and 15% respectively when hexane and pentane are blended with premium gasoline and ethanol blends. PG40E10P fuel blend had the lowest emissions amongst all fuel blend used in spark ignition engine. Hydrocarbons have been seen to diminish with the addition of hexane and pentane. Partial addition of paraffin assisted complete combustion of fuel therby reducing hydrocarbon emissions by 25%. PG60E10P fuel blend found to have least HC emission amongst all fuel blends. In addition, the cylinder pressure dropped when ethanol was added. The maximum braking thermal efficiency was determined to be PG10P as compared to PG . Paraffin blends helped in complete combustion of fuel and hence BTE improved slightly by 7% as compared with PG. A partial addition of paraffin to gasoline was shown to reduce CO emissions by 10% as compared with PG. The nitrogen oxides (NOx) was found to decrease by 25% for PG40EP as compared to PG.
- 1 January 2024
- Published by Engineered Science Publisher in ES Energy and Environment
Experimental investigations on Emission Characteristics of Spark Ignition (S.I) Engines using gasoline-ethanol-alkane blends with different operating conditions
Emission characteristics of spark ignition engine were experimentally investigated using gasoline-ethanol-alkane fuel blend. Optimistic fuel blend were determined using single cylinder spark ignition engine.
- 1 January 2024
- Published by Engineered Science Publisher in ES Energy and Environment
Experimental investigations on Emission Characteristics of Spark Ignition (S.I) Engines using gasoline-ethanol-alkane blends with different operating conditions
Emission characteristics of spark ignition engine were experimentally investigated using gasoline-ethanol-alkane fuel blend. Optimistic fuel blend were determined using single cylinder spark ignition engine.
- 1 January 2024
- Published by Engineered Science Publisher in ES Energy and Environment
Experimental investigations on Emission Characteristics of Spark Ignition (S.I) Engines using gasoline-ethanol-alkane blends with different operating conditions
Emission characteristics of spark ignition engine were experimentally investigated using gasoline-ethanol-alkane fuel blend. Optimistic fuel blend were determined using single cylinder spark ignition engine.
- 1 January 2024
- Published by Engineered Science Publisher in ES Energy and Environment
Experimental investigations on Emission Characteristics of Spark Ignition (S.I) Engines using gasoline-ethanol-alkane blends with different operating conditions
Emission characteristics of spark ignition engine were experimentally investigated using gasoline-ethanol-alkane fuel blend. Optimistic fuel blend were determined using single cylinder spark ignition engine.
- Open Access
- 10 October 2023
- Published by Springer Nature in Research Square
Impact on emission characteristics of Spark Ignition (S.I) engine with spark advancement and retardment using Premium Gasoline- Ethanol blends
Bioethanol is one of the renewable and alternative fuels for conventional gasoline. Bioethanol is manufactured from sugar containing crops like sugarcane, rice straw, etc. by fermentation process. In India, 10% ethanol is already blended with gasoline and 20% will be added by 2024. In this experimental work, different premium gasoline bioethanol blends are prepared and different properties like physical, chemical & Thermodynamic properties of fuel blends are determined. It was found that the lower heating value of premium gasoline bioethanol blends decreases with increasing percentage of bioethanol. Also, density, kinematic viscosity increases with increase in percentage of bioethanol in fuel blend. The research octane number (RON) and motor octane number (MON) is also improved by increasing percentage of bioethanol in premium gasoline ethanol blends. There was enhancement in the Stoichiometric air fuel ratio by increasing quantity of bioethanol in blends. Flash point decreases considerably with increase of percentage of blends. Also, in two wheelers, CO emissions are 33% lower than neat premium gasoline in case of E20 blended fuel. Carbon monoxide, Carbon dioxide, hydrocarbon emissions decreases variation of spark advancement and retardment.
- 10 October 2023
- Published by Springer Nature in Research Square
Open AccessImpact on emission characteristics of Spark Ignition (S.I) engine with spark advancement and retardment using Premium Gasoline- Ethanol blends
Bioethanol is one of the renewable and alternative fuels for conventional gasoline. Bioethanol is manufactured from sugar containing crops like sugarcane, rice straw, etc. by fermentation process. In India, 10% ethanol is already blended with gasoline and 20% will be added by 2024. In this experimental work, different premium gasoline bioethanol blends are prepared and different properties like physical, chemical & Thermodynamic properties of fuel blends are determined. It was found that the lower heating value of premium gasoline bioethanol blends decreases with increasing percentage of bioethanol. Also, density, kinematic viscosity increases with increase in percentage of bioethanol in fuel blend. The research octane number (RON) and motor octane number (MON) is also improved by increasing percentage of bioethanol in premium gasoline ethanol blends. There was enhancement in the Stoichiometric air fuel ratio by increasing quantity of bioethanol in blends. Flash point decreases considerably with increase of percentage of blends. Also, in two wheelers, CO emissions are 33% lower than neat premium gasoline in case of E20 blended fuel. Carbon monoxide, Carbon dioxide, hydrocarbon emissions decreases variation of spark advancement and retardment.