TYTiancheng Yao

Tiancheng Yao

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Tiancheng Yao has a total of 12 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Synthesis of Fe-Co Bimetallic Supported on Cotton Residue Biochar: Catalytic Performance and Mechanistic Investigation for CO2 Hydrogenation

    by Youzhi Yao, Tiancheng Yao, Qinghua Deng, Jiaxin Jiang, Tianyu Wang, Wenjie Wu

    Biochar carriers were prepared from cotton residue waste, and Fe-Co bimetallic catalysts with different ratios were constructed using impregnation method. Their catalytic performance in CO2 hydrogenation to hydrocarbons was investigated. The structural evolution and catalytic behavior of the catalyst were systematically studied through various characterization methods such as XRD, XPS, TEM, BET, and DFT calculations. Based on the characterization of fresh and spent catalysts, the spinel phase of CoFe2O4 in the fresh catalyst is proposed to transform substantially into metallic Fe0 and Co0 upon H2 reduction; during subsequent CO2 hydrogenation, these metallic phases are proposed to partially convert to χ-(Fe1−xCox)5C2 carbides, accompanied by partial graphitization of the biochar support. Because no sample was characterized after H2 reduction but before CO2 hydrogenation, this sequence is inferred. Under the same experimental conditions, Fe15Co5-BC exhibits the best CO2 conversion, with CH4 and C2-C4 alkanes as the main products, indicating that the system possesses bifunctional catalytic characteristics combining CO2 methanation and Fischer–Tropsch synthesis. The CO selectivity exhibited a V-shaped trend with respect to Co loading, with the lowest value achieved at the intermediate Fe/Co ratio (Fe15Co5-BC), mainly attributed to the improved overall CO2 conversion and the efficient conversion of carbon intermediates into hydrocarbons. DFT calculations reveal that Fe-Co bimetallic sites synergistically weaken C-O bonds and thermodynamically favor deep hydrogenation pathways. This work provides experimental and theoretical insights for the application of biochar-based bimetallic catalysts in CO2 hydrogenation.

  • Open Access

    Hydrogen-Induced Cracking Susceptibility of API 5L X100 Steel Welded Joint

    by Chunyan Yan, Lingchuan Zhou, Qianwen Zhou, Tiancheng Yao, Xinyi Liu, Qiqing Lu

    Hydrogen-induced cracking (HIC) is a possible failure mode of high-strength pipeline steel welded joints. The HIC susceptibility of shielded metal arc-welded joint of X100 pipeline steel was investigated using the slow strain rate tensile test (SSRT) under current densities of 2 mA/cm2, 5 mA/cm2, 10 mA/cm2, 20 mA/cm2, and 30 mA/cm2. Hydrogen diffusion behavior, distribution of microstructures, and inclusions in the welded joint were also surveyed and characterized. The SSRT results indicated that the welded joint exhibited a higher hydrogen embrittlement index than the base metal (BM) under the same current density, showing a higher HIC sensitivity than the BM. The weld metal (WM) showed a lower hydrogen diffusivity (5.38 × 10−5 cm2·s−1) than the BM (6.23 × 10−5 cm2·s−1). The martensite–austenite (M-A) constituent area fraction in the WM was higher than that in the coarse-grained heat-affected zone (CGHAZ), fine-grained HAZ (FGHAZ), and BM. The inclusion amount in the WM was larger than that in the BM. In addition, the high HIC vulnerability of the X100 steel welded joint was also associated with a coarse grain size in the WM.

  • Open Access

    Controllable Synthesis of Silver–Copper Bimetallic Nanoparticle-Decorated Reduced Graphene Oxide Composites with Enhanced Electrocatalytic Performance

    by Youzhi Yao, Ping Cheng, Xiaohan Wang, Qinghua Deng, Tiancheng Yao, Jiaxin Jiang, Wenjie Wu

    Monometallic nanoparticles tend to aggregate and exhibit limited catalytic performance, rendering them inadequate for high-efficiency electrocatalytic applications. In this study, a green and mild liquid-phase reduction method was employed, using sodium borohydride to simultaneously reduce graphene oxide (GO) and metal precursors. This approach enabled the uniform and highly dispersed loading of silver–copper bimetallic alloy nanoparticles (Ag1−xCux NPs) onto the surface of reduced graphene oxide (RGO). By tuning the Ag/Cu molar ratio, the size, composition, and morphology of the nanoparticles were precisely controlled. Characterization by scanning electron microscopy (SEM), transmission electron microscopy (TEM), X-ray diffraction (XRD), and X-ray photoelectron spectroscopy (XPS) confirmed that GO was efficiently reduced to RGO, and the bimetallic nanoparticles were uniformly distributed on the RGO surface in an alloy state with small particle size and no obvious agglomeration. A strong interfacial interaction between the metal nanoparticles and the support was also observed. Electrochemical tests demonstrated that the composite exhibits excellent electrocatalytic activity toward the reduction of H2O2. Notably, the reduction peak current at the Ag0.5Cu0.5NPs/RGO modified electrode was 1.8 and 2.3 times higher than those at the monometallic Ag/RGO and Cu/RGO electrodes, respectively. These results provide a reliable theoretical basis and a viable research route for the controllable synthesis of low-cost, high-performance electrocatalytic nanocomposites and their application in electrochemical H2O2 sensing.