Buckling and Stress-Controlled RF MEMS Structures Using Annealing
- 22 December 2025
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Semiconductor Manufacturing
- Vol. 39 (1) , 28-35
Abstract
Micro-Electro-Mechanical System (MEMS) devices show better performance as compared to solid-state devices in terms of radio frequency (RF) response, like insertion loss and isolation. However, MEMS devices face reliability issues, and stress is one of the main concerns. MEMS devices involve many non-traditional fabrication steps, like releasing hanging structures. Released MEMS structures show built-in stress from the fabrication process. This stress can cause them to bend, curl, or buckle. Especially in the case of Radio Frequency (RF) MEMS switches, curling buckling increases the pull-in voltage. In the literature, to address stress-related buckling, thermal annealing was applied at different temperatures after release. However, post-release annealing reduces the stress and results in curled-up and unstable structures. The present paper explores a novel and innovative method for thermally annealing structures at an appropriate stage to reduce stress and buckling in released cantilever structures. Annealing at the appropriate step results in a significant reduction in cantilever bending and warping, indicating effective stress relaxation and yielding straight, mechanically stable cantilevers. After controlling the stress and buckling, the pull-in voltage is reduced to 40 V, which is in close agreement with the simulated results. The measured insertion loss of the switch is -0.4 dB, and isolation is -22 dB for the DC to 20 GHz frequency range.Keywords
Funding Information
- SERB-DST (CRG/2021/008644)
- Department of Telecommunications India and CSIR (MMP-015201)
This publication has 30 references indexed in Scilit:
- Annealing temperature dependence of mechanical and structural properties of chromium-gold films on the silica glass substrateThin Solid Films, 2023
- Design of a wide bandwidth terahertz MEMS Ohmic switch for 6G communication applicationsMicrosystem Technologies, 2023
- Design and performance analysis of a dual channel RF MEMS switch with separate bias voltage and signal paths for aerospace applicationsInternational Journal on Interactive Design and Manufacturing (IJIDeM), 2023
- Stress state mechanism of thickness debit effect in creep performances of a Ni-based single crystal superalloyInternational Journal of Plasticity, 2022
- The effect of thickness on the steady-state creep properties of freestanding aluminum nano-filmsActa Materialia, 2012
- Controlling stress and stress gradient during the release process in gold suspended micro-structuresSensors and Actuators A: Physical, 2010
- RF MEMS2003
- High-isolation CPW MEMS shunt switches. 2. DesignIEEE Transactions on Microwave Theory and Techniques, 2000
- The applicability of Norton's creep power law and its modified version to a single-crystal superalloy type CMSX-2Materials Science and Engineering: A, 1996
- Equivalent circuit representation of electromechanical transducers: I. Lumped-parameter systemsJournal of Micromechanics and Microengineering, 1996