Shear Strain Model for Equal Channel Angular Pressing in High Elastic Extruded Plastics
Open Access
- 13 December 2015
- journal article
- Published by Pakistan Atomic Energy Commission in The Nucleus
- Vol. 52 (4) , 169-175
Abstract
This paper presents a novel model for plastic shear strain calculation in the Equal Channel Angular Pressing (ECAP). The model is particularly formulated to furnish for the elastic recovery after extrusion. Due to high elastic recovery after plastic deformation in polymers, the behavior of Teflon and Nylon is investigated at different temperatures as they are famous for their low coefficient of friction and wall friction effects. The main concentration is given to the basic principle of ECAP processing parameters such as strain, slip bands, and shearing patterns. In this research, a new engraved circle marking technique is used to trace the plastic deformation in the specimens. Afterwards, image analysis approach is applied to measure the deformation, strain and rotation after extrusion. The experimental results are validated with the ABAQUS based numerical simulation. A close conformity is found between them.Keywords
This publication has 21 references indexed in Scilit:
- A new severe plastic deformation method by repetitive extrusion and upsettingMaterials Science and Engineering: A, 2014
- Effect of die channel angle, friction and back pressure in the equal channel angular pressing using 3D finite element simulationMaterials Science and Engineering: A, 2010
- Equal channel angular pressing die to extrude a variety of materialsMaterials & Design (1980-2015), 2009
- Microtexture and microstructure evolution during processing of pure aluminum by repetitive ECAPMaterials Science and Engineering: A, 2006
- Effect of temperature on texture formation of 6061 aluminum sheet in equal-channel angular pressingMaterials Science and Engineering: A, 2005
- Scaling up of equal-channel angular pressing and its effect on mechanical properties, microstructure, and hot workability of AA 6061Materials Science and Engineering: A, 2005
- Characteristic of textures evolution induced by equal channel angular pressing in 6061 aluminum sheetsScripta Materialia, 2004
- Shear, principal, and equivalent strains in equal-channel angular deformationMetallurgical and Materials Transactions A, 2001
- Principle of equal-channel angular pressing for the processing of ultra-fine grained materialsScripta Materialia, 1996
- Materials processing by simple shearMaterials Science and Engineering: A, 1995