Evaluation and Improvement of Uniformity in km-Class MgB2 Superconducting Wires
- 12 January 2024
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Applied Superconductivity
- Vol. 34 (3) , 1-5
Abstract
An 18-multifilamentary MgB 2 wire, classified within the 250 m-class, was produced utilizing a technique to improve the uniformity of powder filling by employing three-dimensional vibrators. A comprehensive evaluation of the fabricated wire revealed that the uniformity of the critical current ( I c ) and fill factor, determined through the coefficient of variation, were 2 and 4%, respectively, along the wire direction. Building upon this achievement, a scaled-up MgB 2 wire was fabricated, with dimensions of approximately 3 km in length and 0.83 mm in diameter. At 20 K and 2 T, the I c was measured to be 191 A. The corresponding critical current density ( J c ), determined to be 190,000 A/cm 2 , represents a significant improvement when compared to that yielded by the conventional gravity-based powder filling method.Keywords
Funding Information
- Ministry of Science and ICT, South Korea
- National R&D Program, National Research Foundation of Korea (2022M3I9A1076881)
- Gangwon Province, Kangwon High Magnetic Field Research Center
- Gangwon Technopark
This publication has 14 references indexed in Scilit:
- Customized MgB2 Superconducting Wire Toward Practical Applications at Sam Dong in KoreaJournal of Superconductivity and Novel Magnetism, 2018
- Towards liquid-helium-free, persistent-mode MgB 2 MRI magnets: FBML experienceSuperconductor Science and Technology, 2017
- A persistent-mode 0.5 T solid-nitrogen-cooled MgB 2 magnet for MRISuperconductor Science and Technology, 2016
- The BEST PATHS Project on MgB2Superconducting Cables for Very High Power TransmissionIEEE Transactions on Applied Superconductivity, 2016
- Characterization of the Critical Current Capabilities of Commercial REBCO Coated Conductors for an HTS Cable-in-Conduit ConductorIEEE Transactions on Applied Superconductivity, 2014
- Characterization of Mechanical Properties of MgB2 conductor for Superconducting Link Project at CERNIEEE Transactions on Applied Superconductivity, 2014
- Application of SMES and Fuel Cell System Combined With Liquid Hydrogen Vehicle Station to Renewable Energy ControlIEEE Transactions on Applied Superconductivity, 2011
- As-deformed filament's density and transport currents of MgB2/Ti/Glidcop wireJournal of Alloys and Compounds, 2011
- Development of magnesium diboride (MgB2) wires and magnets using in situ strand fabrication methodPhysica C: Superconductivity and its Applications, 2007
- Superconductivity at 39 K in magnesium diborideNature, 2001