Design of soft x-ray high diffraction efficiency and spectral flux Au/Ni bilayer coated laminar-type diffraction grating for objective soft x-ray flat-field spectrograph in a region of 250–550 eV
- 1 December 2024
- journal article
- research article
- Published by AIP Publishing in Review of Scientific Instruments
- Vol. 95 (12)
Abstract
An objective soft x-ray flat-field spectrograph employing a laminar-type bilayer coated, varied-line-spacing, spherical grating was designed to improve the detection limit and sensitivity of soft x-ray flat-field spectrographs in a region of 250–550 eV. As a design criterion, spectral flux, SF, [Hatano et al., Appl. Opt. 60, 4993–4999 (2021)], which is proportional to the amount of optical flux incident onto a detector and correlated with detection sensitivity, was used to be maximized. To enhance reflectivity with the coating design, Au/Ni bilayer coating was investigated to optimize the incidence angle and thickness of the Ni layer. This is based on the consideration that, in an energy region of over 400 eV, refractive indices of Au (bottom layer), Ni (top layer), and vacuum are increased from the bottom to the top of the layers, and a supplemental enhancement of reflectivity can be expected by optimizing the thickness of the top layer. Thus, the thickness of Ni and the incidence angle were chosen to be 8.0 nm and 86.00°, respectively. To maintain dispersion and spectral resolution of the grating used at an incidence angle of 87.07° as previously designed, groove density was increased to 1500 lines/mm from 1200 lines/mm of our previous design. Finally, a holographic, varied-line-spacing, spherical grating was designed assuming an aspherical-wavefront-recording configuration. The numerical simulation results showed that the spectrograph employing newly designed grating with laminar-type grooves and Au/Ni bilayer coating exhibited 2–18 times higher spectral flux as well as an improved spectral resolution compared with those obtained with the previously designed gratings and spectrographs.Keywords
This publication has 12 references indexed in Scilit:
- Laminar-type gratings overcoated with carbon-based materials to enhance analytical sensitivity of flat-field emission spectrograph in the VUV regionReview of Scientific Instruments, 2023
- Synchrotron Light Sources and Free-Electron Lasers2020
- Electronic Structure of Polymer Dielectrics: The Role of Chemical and Morphological ComplexityChemistry of Materials, 2018
- Development of an objective flat-field spectrograph for electron microscopic soft x-ray emission spectrometry in 50-4000 eV2013
- Development of wavelength-dispersive soft X-ray emission spectrometers for transmission electron microscopes--an introduction of valence electron spectroscopy for transmission electron microscopyJournal of Electron Microscopy, 2010
- Performance of laminar-type holographic grating for a soft x-ray flat-field spectrograph in the 0.7–6 nm regionReview of Scientific Instruments, 2003
- Broadband normal-incidence aperiodic multilayer mirrors for soft X-ray dispersive spectroscopy: theory and implementation2002
- On the determination of carbon sp2/sp3 ratios in polystyrene–polyethylene copolymers by photoelectron spectroscopyThin Solid Films, 2001
- Optimization and evaluation of varied line spacing plane grating monochromators for third-generation synchrotron radiation sourcesJournal of Electron Spectroscopy and Related Phenomena, 1996
- Extended Rayleigh–Fano theory and its application to grating polarizationApplied Optics, 1991