Steven Kleijn
Steven Kleijn has a total of 9 co-authors. Here are the top co-authors by number of shared publications:
- Marcin Zyskowski
Integrated and Quantum Optics Unit Fondazione Bruno Kessler 38123 Povo Italy
2 shared publications - Akanksha Kapoor
Univ. Grenoble Alpes, CEA, Grenoble INP, IRIG, PHELIQS, NPSC, Grenoble, 38000, France
1 shared publication - Aref Rasoulzadeh Zali
Department of Electrical Engineering, Eindhoven University of Technology and the Eindhoven Hendrik Casimir Institute (EHCI), Eindhoven, The Netherlands
1 shared publication - Francisco Javier Díaz Otero
University of Vigo
1 shared publication - Luc Augustin
Eindhoven University of Technology
1 shared publication - Netsanet Tessema
IPI-ECO Research Institute, Eindhoven University of Technology, Eindhoven, The Netherlands
1 shared publication
Latest Publications
- 16 December 2024
- Published by Wiley in Physica Status Solidi (b)
- Vol. 262 (11)
Influence of Precursor Concentration on the Determination of AlInGaAs Solid‐State Compositions Grown by Metalorganic Vapor Phase Epitaxy
The epitaxial growth of AlInGaAs alloys on InP allows the manufacture of semiconductor lasers that emit in the wavelength range between 1200 and 1600 nm in which the optical telecommunication bands lie. These alloys are particularly well suited for manufacturing lasers intended for operation at higher temperatures. A model relating the metalorganic vapor phase epitaxy (MOVPE) growth settings for AlInGaAs on InP to the resultant bandgap energy is presented, for strained and unstrained compositions, based on a new dataset measured on epitaxial layers grown in a novel planetary epitaxy reactor, using the 12x4 inch configuration. Elemental analysis (ICP‐OES) was employed to relate the growth settings to the solid‐state composition of the resulting alloy, to ensure our model takes meaningful input. It was found that the MOVPE growth settings and the solid‐state composition as determined by ICP‐OES only showed a one‐to‐one correspondence once the right set of vapor pressure coefficients for the precursors was chosen.
- 16 December 2024
- Published by Wiley in Physica Status Solidi (b)
- Vol. 262 (11)
Influence of Precursor Concentration on the Determination of AlInGaAs Solid‐State Compositions Grown by Metalorganic Vapor Phase Epitaxy
The epitaxial growth of AlInGaAs alloys on InP allows the manufacture of semiconductor lasers that emit in the wavelength range between 1200 and 1600 nm in which the optical telecommunication bands lie. These alloys are particularly well suited for manufacturing lasers intended for operation at higher temperatures. A model relating the metalorganic vapor phase epitaxy (MOVPE) growth settings for AlInGaAs on InP to the resultant bandgap energy is presented, for strained and unstrained compositions, based on a new dataset measured on epitaxial layers grown in a novel planetary epitaxy reactor, using the 12x4 inch configuration. Elemental analysis (ICP‐OES) was employed to relate the growth settings to the solid‐state composition of the resulting alloy, to ensure our model takes meaningful input. It was found that the MOVPE growth settings and the solid‐state composition as determined by ICP‐OES only showed a one‐to‐one correspondence once the right set of vapor pressure coefficients for the precursors was chosen.
- Open Access
- 26 December 2023
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 134 (24)
Strained AlGaInAs on InP: Bandgap dependence on composition—Model benchmark and optimization
Influence of chemical composition on the bandgap of AlGaInAs deposited on InP is often calculated using models for unstrained composition and then corrected for strain-induced bandgap energy changes using deformation potentials. This method relies on up to 25 coefficients, many of which are burdened with large uncertainty. In this paper, a large set of experimental data is used to verify the accuracy of existing approaches and to search for optimal deformation potentials. It is shown that the main source of inaccuracy is not the deformation potentials, but the unstrained bandgap formulas. Additionally, a novel model is proposed, yielding the highest accuracy on our dataset. For the first time, composition determination of a quaternary alloy on InP is reported using inductively coupled plasma-optical emission spectrometry, which is used as a benchmark for modeling.
- 26 December 2023
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 134 (24)
Open AccessStrained AlGaInAs on InP: Bandgap dependence on composition—Model benchmark and optimization
Influence of chemical composition on the bandgap of AlGaInAs deposited on InP is often calculated using models for unstrained composition and then corrected for strain-induced bandgap energy changes using deformation potentials. This method relies on up to 25 coefficients, many of which are burdened with large uncertainty. In this paper, a large set of experimental data is used to verify the accuracy of existing approaches and to search for optimal deformation potentials. It is shown that the main source of inaccuracy is not the deformation potentials, but the unstrained bandgap formulas. Additionally, a novel model is proposed, yielding the highest accuracy on our dataset. For the first time, composition determination of a quaternary alloy on InP is reported using inductively coupled plasma-optical emission spectrometry, which is used as a benchmark for modeling.
- 18 September 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in Journal of Lightwave Technology
- Vol. 42 (2) , 780-792
Assessment of Low Polarization Dependent Multicast and Select Switch Based on Bulk SOA for Data Center Application
We have designed, fabricated, and characterized a low polarization dependent multicast and select (MCS) switch based on a newly developed novel bulk SOA co-integrated with passive waveguides. The proposed new bulk SOA-based MCS switch requires the co-integration of active SOAs (gate and booster) with several passive InP elements. First, we have presented a theoretical analysis and the design and properties of the proposed bulk SOA and demonstrated its low polarization-dependent properties. Then, we evaluated and characterized the switch's performance, including gain, optical signal-to-noise ratio (OSNR), and data transmission features. The experimental results verify that the MCS switch exhibits polarization-dependent gain in the range of 0.1 to 2.2 dB for all ports and a broadband gain of approximately 70 nm across all ports. The measured OSNR, for all channels, is > 42 dB at 1580 nm. Moreover, experimental data transmission assessments show operation at high bitrates of 30 Gb/s with a low power penalty of less than 1 dB at 10 −9 . The dynamic power penalty range of the switch is also investigated. The MCS switch exhibits a wide range of > 20 dB input power dynamic range for a power penalty of less than 3 dB for a 10 Gb/s NRZ signal.
- 18 September 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in Journal of Lightwave Technology
- Vol. 42 (2) , 780-792
Assessment of Low Polarization Dependent Multicast and Select Switch Based on Bulk SOA for Data Center Application
We have designed, fabricated, and characterized a low polarization dependent multicast and select (MCS) switch based on a newly developed novel bulk SOA co-integrated with passive waveguides. The proposed new bulk SOA-based MCS switch requires the co-integration of active SOAs (gate and booster) with several passive InP elements. First, we have presented a theoretical analysis and the design and properties of the proposed bulk SOA and demonstrated its low polarization-dependent properties. Then, we evaluated and characterized the switch's performance, including gain, optical signal-to-noise ratio (OSNR), and data transmission features. The experimental results verify that the MCS switch exhibits polarization-dependent gain in the range of 0.1 to 2.2 dB for all ports and a broadband gain of approximately 70 nm across all ports. The measured OSNR, for all channels, is > 42 dB at 1580 nm. Moreover, experimental data transmission assessments show operation at high bitrates of 30 Gb/s with a low power penalty of less than 1 dB at 10 −9 . The dynamic power penalty range of the switch is also investigated. The MCS switch exhibits a wide range of > 20 dB input power dynamic range for a power penalty of less than 3 dB for a 10 Gb/s NRZ signal.